Table Of Contents
G Commands
This chapter describes the Cisco NX-OS security commands that begin with G.
gt
To specify a greater-than group member for an IP port object group, use the gt command. A greater-than group member matches port numbers that are greater than (and not equal to) the port number specified in the member. To remove a greater-than group member from the port-object group, use the no form of this command.
[sequence-number] gt port-number
no {sequence-number | gt port-number}
Syntax Description
Defaults
None
Command Modes
IP port object group configuration
Supported User Rolesnetwork-admin
vdc-adminCommand History
Usage Guidelines
IP port object groups are not directional. Whether a gt command matches a source or destination port or whether it applies to inbound or outbound traffic depends upon how you use the object group in an ACL.
This command does not require a license.
Examples
This example shows how to configure an IP port object group named port-group-05 with a group member that matches traffic sent to or from port 49152 through port 65535:
switch# config tswitch(config)# object-group ip port port-group-05switch(config-port-ogroup)# gt 49151Related Commands