Cisco DCNM Interfaces Configuration Guide, Release 4.1
New and Changed Information
Downloads: This chapterpdf (PDF - 81.0KB) The complete bookPDF (PDF - 7.22MB) | Feedback

New and Changed Information

Table Of Contents

New and Changed Information


New and Changed Information


This chapter provides release-specific information for each new and changed feature in the Cisco DCNM Interfaces Configuration Guide, Release 4.1. The latest version of this document is available at the following Cisco website:
http://www.cisco.com/en/US/docs/switches/datacenter/sw/4_1/nx-os/interfaces/configuration/guide/int_nx-os_config.html

To check for additional information about Cisco DCNM Release 4.1, see the Cisco DCNM Release Notes available at the following Cisco website:
http://www.cisco.com/en/US/docs/switches/datacenter/sw/4_1/dcnm/release/notes/41_dcnm_release_note.html

summarizes the new and changed features for the Cisco DCNM Interfaces Configuration Guide, Release 4.1, and tells you where they are documented.

Table 1 New and Changed Features for Release 4.1 

Feature
Description
Changed in Release
Where Documented

SFP information

Added display information on SFP interfaces.

4.1(2)

Chapter 2, "Configuring Basic Interface Parameters"

Carrier delay

Configures a timer that allows you to not see some quick interface up/down changes.

4.1(2)

Chapter 2, "Configuring Basic Interface Parameters"

Dedicated mode

Allows you to configure specified interfaces in dedicated or shared mode.

4.1(2)

Chapter 2, "Configuring Basic Interface Parameters"

Virtual port channels (vPCs)

Allows a third device to see two upstream, linked devices as a single device.

4.1(3)

Chapter 6, "Configuring vPCs"

Virtual port channels (vPCs)

Increases support for vPCs to 192.

4.1(4)

Chapter 6, "Configuring vPCs"