The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter provides release-specific information for each new and changed feature in the Cisco Nexus 7000 Series NX-OS Virtual Device Context Command Reference. The latest version of this document is available at the following Cisco website:
http://www.cisco.com/c/en/us/support/switches/nexus-7000-series-switches/products-command-reference-list.html
To check for additional information about this Cisco NX-OS Release, see the Cisco NX-OS Release Notes available at the following Cisco website:
http://www.cisco.com/c/en/us/support/switches/nexus-7000-series-switches/products-release-notes-list.html
Table 1 summarizes the new and changed features for the Cisco Nexus 7000 Series NX-OS Virtual Device Context Command Reference and tells you where they are documented.
|
|
|
|
---|---|---|---|
The management interface on each VDC that is supported in the NX-OS software has a unique MAC address. |
|||
limit-resource module-type, limit-resource monitor-session-erspan-dst |
|||
The range for the minimum and maximum values changed for several limit-resource commands. |
limit-resource m4route-mem, limit-resource m6route-mem, limit-resource u4route-mem, limit-resource u6route-mem, limit-resource vrf |
||
Added the boot-order command to control the order in which the nondefault VDC boot up. |
|||
Added the vdc combined-hostname command to add or remove the hostname in the nondefault VDC CLI prompts. |
|||
Added the vdc suspend command to suspend and resume nondefaulot VDCs. |
|||
Added commands to set resource limits for IPv4 and IPv6 multicast resource limits. |