Cisco Nexus 6000 Series NX-OS Unicast Routing Command Reference
S Commands
Downloads: This chapterpdf (PDF - 76.0 KB) The complete bookPDF (PDF - 4.5 MB) | Feedback

S Commands

Table Of Contents

S Commands

shutdown (VRRP)

S Commands

This chapter describes the Cisco NX-OS Virtual Router Redundancy Protocol (VRRP) commands that begin with S.

shutdown (VRRP)

To disable a Virtual Router Redundancy Protocol (VRRP) configuration, use the shutdown command. To enable a VRRP configuration, use the no form of this command.


no shutdown

Syntax Description

This command has no arguments or keywords.

Command Default


Command Modes

VRRP configuration mode

Command History



This command was introduced.

Usage Guidelines

Shut down the virtual router before configuring the virtual router parameters; you can only configure the virtual router after it is in the administrative shut down state. Enter the no shutdown command to update the virtual router state after completing configuration.


This example shows how to shut down a VRRP group:

switch# configure terminal
switch(config)# interface ethernet 2/3
switch(config-if)# no switchport
switch(config-if)# vrrp 45
switch(config-if-vrrp)# shutdown
switch(config-if-vrrp)# address
switch(config-if-vrrp)# no shutdown

Related Commands


feature vrrp

Enables VRRP.

show vrrp

Displays VRRP configuration information.

clear vrrp

Clears all the software counters for the specified virtual router.