Cisco Nexus 6000 Series NX-OS Unicast Routing Command Reference
A Commands
Downloads: This chapterpdf (PDF - 58.0KB) The complete bookPDF (PDF - 7.33MB) | Feedback

Table of Contents

A Commands

address-family (RIP)

A Commands

This chapter describes the Cisco NX-OS Routing Information Protocol (RIP) commands that begin with A.

address-family (RIP)

To configure an address family for the Routing Information Protocol (RIP), use the address-family command in router configuration mode.

address-family ipv4 unicast

 
Syntax Description

ipv4

Specifies the IPv4 address family.

unicast

Specifies unicast address support.

 
Command Default

This command has no default settings.

 
Command Modes

Router configuration mode

 
Command History

Release
Modification

6.0(2)N1(1)

This command was introduced.

Examples

This example shows how to set the IPv4 unicast address family for a RIP instance:

switch(config)# router rip Enterprise
switch(config-router)# address-family ipv4 unicast
 

 
Related Commands

Command
Description

default-information

Controls the distribution of a default route.

default-metric

Configures the default metric for routes redistributed into RIP.

distance

Configures the administrative distance.

maximum-paths

Configures the maximum number of equal-cost paths.

redistribute

Configures route redistribution for RIP.

show ip rip

Displays a summary of RIP information for all RIP instances.

timers

Configures the RIP timers.