Cisco Nexus 6000 Series NX-OS Unicast Routing Command Reference
V Commands
Downloads: This chapterpdf (PDF - 56.0 KB) The complete bookPDF (PDF - 4.32 MB) | Feedback

Table of Contents

V Commands

vrf member

V Commands

This chapter describes the Cisco NX-OS object tracking commands that begin with V.

vrf member

To add an interface to a virtual routing and forwarding (VRF) instance or to configure object tracking on a VRF instance, use the vrf member command. To remove the object tracking for this route, use the no form of this command.

vrf member vrf-name

no vrf member vrf-name

Syntax Description


VRF name. The name can be any case-sensitive, alphanumeric string up to 32 characters.

Command Default


Command Modes

Interface configuration mode
Object tracking confiuration mode

Command History



This command was introduced.

Usage Guidelines

Use the vrf member command in object tracking configuration mode to track objects in a nondefault VRF.


This example shows how to track an IP route in VRF Red:

switch(config)# track 1 ip route reachability
switch(config-track)# vrf member Red

This example shows how to add the Ethernet interface 1/5 to VRF RemoteOfficeVRF:

switch(config)# interface ethernet 1/5
switch(config-if)# no switchport
switch(config-if)# vrf member RemoteOfficeVRF

Related Commands


show ip eigrp

Displays Enhanced Interior Gateway Routing Protocol (EIGRP) information.

show ip ospf interface

Displays Open Shortest Path First (OSPF) interface-related information.

show ip rip

Displays a summary of RIP information for all RIP instances.

show track

Displays information about object tracking.

track ip route

Tracks an interface.