Cisco Nexus 6000 Series NX-OS Interfaces Command Reference
M Commands
Downloads: This chapterpdf (PDF - 70.0KB) The complete bookPDF (PDF - 1.28MB) | Feedback

M Commands

Table Of Contents

M Commands

management


M Commands


This chapter describes the Cisco NX-OS interface commands that begin with M.

management

To configure a switch virtual interface (SVI) that should be used for in-band management, use the management command. To remove the in-band management access to a VLAN interface IP address, use the no form of this command.

management

no management

Syntax Description

This command has no arguments or keywords.

Command Default

None

Command Modes

Interface configuration mode
Switch profile configuration mode

Command History

Release
Modification

6.0(2)N1(1)

This command was introduced.


Usage Guidelines

You can use this command on a VLAN interface.

Examples

This example shows how to configure a VLAN interface to allow in-band management access:

switch# configure terminal
switch(config)# interface vlan 5
switch(config-if)# management
switch(config-if)#
 
   

This example shows how to remove the in-band management access to a VLAN interface:

switch# configure terminal
switch(config)# interface vlan 5
switch(config-if)# no management
switch(config-if)#
 
   

Related Commands

Command
Description

show running-config interface

Displays the running configuration information for an interface.