The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS Virtual Router Redundancy Protocol (VRRP) commands that begin with F.
To enable the Virtual Router Redundancy Protocol (VRRP), use the feature vrrp command. To disable VRRP, use the no form of this command.
|
|
---|---|
You must enable the VRRP feature before you can configure VRRP.
This command does not require a license.
Note Make sure the LAN Base Services license is installed on the switch to enable Layer 3 interfaces.
This example shows how to enable the VRRP feature:
This example shows how to disable the VRRP feature:
|
|
---|---|
Clears all the software counters for the specified virtual router. |
|
To enable the Virtual Router Redundancy Protocol (VRRP) version 3 and Virtual Router Redundancy Service (VRRS), use the feature vrrpv3 command. To disable VRRPv3 and VRRS, use the no form of this command.
|
|
---|---|
If VRRPv2 is configured, use the no feature vrrp command in global configuration mode to remove the VRRPv2 configuration and then use the feature vrrpv3 command to enable VRRPv3.
The following example shows how to enable the VRRPv3 and VRRS:
The following example shows how to disable VRRPv3 and VRRS:
|
|
---|---|
Creates a VRRPv3 group and enters VRRPv3 group configuration mode. |