-
null
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS quality of service (QoS) commands that begin with B.
To allocate a minimum percentage of the interface bandwidth to a queue and configure the bandwidth on both ingress and egress queues, use the bandwidth command. To remove a bandwidth configuration, use the no form of this command.
bandwidth percent percent
no bandwidth percent percent
percent |
Specifies the percentage of bandwidth of the underlying link rate. |
percent |
Percent value. The range is from 0 to 100. |
Default bandwidth rate is kbps.
Policy map type queuing class configuration
|
|
---|---|
5.0(2)N1(1) |
This command was introduced. |
This example shows how to set the bandwidth for the specified queue:
switch(config)# policy-map type queuing my_policy1
switch(config-pmap-que)# class type queuing 1p7q4t-out-pq1
switch(config-pmap-c-que)# bandwidth percent 25
switch(config-pmap-c-que)#
This example shows how to remove the bandwidth for the specified queue:
switch(config)# policy-map type queuing my_policy1
switch(config-pmap-que)# class type queuing 1p7q4t-out-pq1
switch(config-pmap-c-que)# no bandwidth percent 25
switch(config-pmap-c-que)#
|
|
---|---|
show class-map |
Displays class maps. |
show policy-map |
Displays policy maps. |