Cisco Nexus 5000 Series NX-OS Multicast Routing Configuration Guide, Release 5.0(3)N1(1)
New and Changed Information
Downloads: This chapterpdf (PDF - 55.0 KB) The complete bookPDF (PDF - 1.24 MB) | Feedback

Table of Contents

New and Changed Information

New and Changed Information

This chapter provides release-specific information for each new and changed feature in the Cisco Nexus 5000 Series NX-OS Multicast Routing Configuration Guide, Release 5.0(3)N1(1). The latest version of this document is available at the following Cisco website:

http://www.cisco.com/en/US/products/ps9670/products_installation_and_configuration_guides_list.html

To check for additional information about this Cisco NX-OS Release, see the Cisco Nexus 5000 Series Switch Release Notes , available at the following Cisco website:

http://www.cisco.com/en/US/products/ps9670/prod_release_notes_list.html

Table 1 summarizes the new and changed features for the Cisco Nexus 5000 Series NX-OS Multicast Routing Configuration Guide, Release 5.0(3)N1(1), and tells you where they are documented.

 

Table 1 New and Changed Features for Release 5.0(3)N1(1)

Feature
Description
Changed in Release
Where Documented

IGMP

This feature was introduced.

You can configure the following Internet Group Management Protocol (IGMP) features on Cisco NX-OS switches for IPv4 networks:

  • Interface parameters
  • Source-Specific Multicast (SSM) translation
  • Enforce router alert option check

5.0(3)N1(1)

Chapter 1, “Configuring IGMP”

IGMP Snooping

You can configure the following IGMP snooping parameters for Layer 3 interfaces on Cisco NX-OS switches:

  • Explicit tracking
  • Fast leave
  • Last member query interval
  • Snooping querier
  • Report suppression
  • Multicast router
  • Static group
  • Link-local groups suppression
  • IGMPv3 report suppression

5.0(3)N1(1)

Chapter 1, “Configuring IGMP Snooping”

PIM

This feature was introduced.

You can configure the following Protocol Independent Multicast (PIM) features on Cisco NX-OS switches in your IPv4 networks:

  • PIM sparse mode
  • Any Source Multicast (ASM)
  • Source-Specific Multicast (SSM)
  • RPF routes for multicast
  • Route maps
  • PIM message filters

5.0(3)N1(1)

Chapter 1, “Configuring PIM”

MSDP

This feature was introduced.

You can configure the following Multicast Source Discovery Protocol (MSDP) features on Cisco NX-OS switches:

  • MSDP peers
  • MDSP global parameters
  • MDSP mesh groups

5.0(3)N1(1)

Chapter 1, “Configuring MSDP”