This document describes the features, caveats, and limitations for Cisco NX-OS Release 7.0(3)F3(5) software for use on Cisco Nexus C3636C-R and C36180YC-R switches. Use this document in combination with documents listed in Related Documentation.
Note: Cisco NX-OS Release 7.0(3)F3(5) for use on the Cisco Nexus C3636C-R and C36180YC-R switches.
______________________________________________________________________________________________
Table 1 shows the online change history for this document.
Table 1. Online History Change
Date |
Description |
March 5, 2019 |
Created the release notes for Release 7.0(3)F3(5). |
Resolved Caveats—Cisco NX-OS Release 7.0(3)F3(5)
Open Caveats—Cisco NX-OS Release 7.0(3)F3(5)
Obtaining Documentation and Submitting a Service Request
Cisco NX-OS software is a data center-class operating system designed for performance, resiliency, scalability, manageability, and programmability at its foundation. The Cisco NX-OS software provides a robust and comprehensive feature set that meets the requirements of virtualization and automation in mission-critical data center environments. The modular design of the Cisco NX-OS operating system makes zero-impact operations a reality and enables exceptional operational flexibility.
The Cisco NX-OS 7.0(3)F3(5) image is specifically designed to support and bring up the N3K-C3636C-R and N3K-C36180YC-R switches of the Cisco Nexus 3600 platform switches.
Temporary licenses with an expiry date are available for evaluation and lab use purposes. They are strictly not allowed to be used in production. Please use a permanent or subscription license that has been purchased through Cisco for production purposes.
For more information, see the Cisco NX-OS Licensing Guide.
This section includes the following sections:
Table 2 lists the Cisco Nexus 3600 switch hardware that Cisco NX-OS Release 7.0(3)F3(5) supports. For additional information about the supported hardware, see the Cisco Nexus 3600 NX-OS Mode Switch Hardware Installation Guide.
Table 2. Cisco Nexus 3600 Switch Hardware
Product ID |
Hardware |
N3K-C3636C-R |
The Cisco Nexus 3636C-R (N3K-C3636C-R) is a 1 rack unit (RU) switch with 36 100-Gigabit QSFP28 ports. 2 management ports, 1 console port, and 1 USB port. The switch supports both port-side exhaust and port-side intake airflow schemes. The switch has two power supplies, one for operations and the other for redundancy. Both power supplies must be either AC power supplies or DC power supplies. |
N3K-C36180YC-R
|
The Cisco Nexus 36180YC-R (N3K-C36180YC-R) is a 1 rack unit (RU) switch with 48 1/10/25-Gigabit SFP ports and 6 40-Gigabit QSFP/100-Gigabit QSFP28 ports, 1 management port, 1 console port, and 1 USB port. The switch supports both port-side exhaust and port-side intake airflow schemes. The switch has two power supplies, one for operations and the other for redundancy. Both power supplies must be either AC power supplies or DC power supplies. |
See the Cisco Transceiver Modules Compatibility Information for a list of supported optical components.
This section lists the following topic:
■ New Software Features in Cisco NX-OS Release 7.0(3)F3(5)
Cisco NX-OS Release 7.0(3)F3(5) has no hardware features.
Cisco NX-OS Release 7.0(3)F3(5) has no software features.
The following table lists the resolved bugs in Cisco NX-OS Release 7.0(3)F3(5). You can use the bug ID to access the Cisco Bug Search Tool and see additional information about the bug.
Bug ID |
Description |
Cisco NX-OS Software CLI Arbitrary Command Execution Vulnerability |
|
Cisco NX-OS System Software Interactive TCL Shell Escape Vulnerability |
|
N9K USB not detected after OIR |
|
copy running-config to startup-config failed due to Service "policyelem" |
|
Vulnerable version of libxml2 present in line cards |
|
No Syslog message for Login On-Success Event |
|
Redirected IP packet not forwarded to destination |
|
Account for cable type to choose FEC mode for 25G ports |
|
Cisco NX-OS Authenticated SNMP Denial of Service Vulnerability |
|
Cisco NXOS Software Authenticated Simple Network Management Protocol Denial of Service Vulnerability |
|
BIOS upgrade may fail during install all |
|
Nexus 9500-R, Nexus 3000-R // 7.0(3)F3(3) // slot 1 quoted "show hardware internal.." crashes box |
The following table lists the open caveats in Cisco NX-OS Release 7.0(3)F3(5). Click the bug ID to access the Cisco Bug Search Tool and see additional information about the bug.
Bug ID |
Description |
On SVI interfaces, post routed packets may be dropped momentarily (till MAC is learnt) |
|
Queue-limit Sum more than 100% |
|
breakout priority drops when 3 streams comes from same soc under oversubscription |
|
N3K-C36180YC-R can't mix 1/10G and 25G in the same port group. |
|
Mcast RPF Nbr IP showing local switch intf IP when /16 bit mask used on PIM intfs |
|
N9K-X9636C-RX:: L2 SSM look up failure affecting IGMPv3 functionality |
|
port range not working properly |
|
L2GW : Outer IP TOS value to set as 0x00 |
|
Storm control counters not incrementing |
|
packet is flooded to the port which has no receiver |
|
Unshut of One of the ECMP links causes 1 minute + traffic drop due to high CPU for u6rib |
|
1G copper GLC-TE XCVR LED state is GREEN when link is not connected |
|
vpc secondary comes back up as oper primary after reload |
|
QoS with "match protocol apr" on L3/SVI returning 'Failed to add acl in hardware' |
|
Level 2 priority is not honored, which policy applied on per port level |
|
N3K-C36180YC-R 1G port, priority traffic is not honored |
|
“VLAN dot1q tag native” config/unconfig takes effect only after trunk port flap |
|
Console hung after executing default interface command |
|
7.0(3)F - snmp-server host informs config corruption - also DME conflict |
|
fragments permit-all and deny-all |
|
Ports for module N9K-X9636C-RX in error disable state after upgrade from MR2 to MR3 image |
|
Traffic drop for low priority unicast traffic on the egress port |
|
Multicast traffic in L2 range 0100.5e00.xxxx - 0100.5e7f.xxxx not denied by access-list |
|
sflow sample packets not taking correct copp class |
|
L3 routed port rewriting dst macs to 0000.0000.0000 |
|
Intermediate link failure on some ports of N3K-C36180YC-R/N3K-C3636C-R/N9K-X96160YC-R |
This section lists limitations related to Cisco NX-OS Release 7.0(3)F3(5).
■ The PTP process restart and system switchover accumulates high corrections for a few seconds. For more information, see CSCvg49023.
■ The LDP neighbor might flap on switchover in a scaled setup with many interfaces. Increase the discovery hello hold time for MPLS under the MPLS LDP configuration. For more information, see CSCvg71349.
■ CoPP (Control Plane Policing) cannot be disabled. If you attempt to disable it, an error message appears. For more information, see CSCvi09329.
■ The skip CoPP policy option has been removed from the Cisco NX-OS initial setup utility because using it can impact the control plane of the network. For more information, see CSCvc44819.
■ IPv4 traffic might drop when only IPv6 uRPF is enabled on the interface. For more information, see CSCvh99632.
The entire Cisco Nexus 3600 NX-OS documentation set is available at the following URL:
https://www.cisco.com/c/en/us/support/switches/nexus-3000-series-switches/tsd-products-support-series-home.html
The Cisco Nexus 3600 NX-OS Hardware Installation Guide is available at the following URL:
The Cisco Nexus 3600 NX-OS Verified Scalability Guide, Release 7.0(3)F3(5) is available at the following URL:
To provide technical feedback on this document, or to report an error or omission, please send your comments to nexus3k-docfeedback@cisco.com. We appreciate your feedback.
For information on obtaining documentation and gathering additional information, see the monthly What’s New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at:
http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html
Open a service request online at:
https://tools.cisco.com/ServiceRequestTool/create/launch.do
Subscribe to the What’s New in Cisco Product Documentation as a Really Simple Syndication (RSS) feed and set content to be delivered directly to your desktop using a reader application. The RSS feeds are a free service and Cisco currently supports RSS version 2.0.
This product includes cryptographic software written by Eric Young (eay@cryptsoft.com). This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit. (http://www.openssl.org/). This product includes software written by Tim Hudson (tjh@cryptsoft.com).
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1110R)
Cisco Nexus 3600 Series NX-OS Release Notes, Release 7.0(3)F3(5)
© 2019 Cisco Systems, Inc. All rights reserved.