Cisco Nexus 1000V Port Profile Configuration Guide, Release 4.0(4)SV1(2)
New and Changed Information
Downloads: This chapterpdf (PDF - 85.0KB) The complete bookPDF (PDF - 1.83MB) | Feedback

New and Changed Information

Table Of Contents

New and Changed Information


New and Changed Information


This section describes the information in this document that is either new or has changed with Release 4.0(4)SV1(2).

To find additional information about new features or command changes in Release 4.0(4)SV1(2), see the following:

Release Notes.

Command Reference.

Feature
Description
Changed in release
Where Documented

Uplink port profile

Port profiles are not classified as uplink, but are, instead, configured as Ethernet or vEthernet.

4.0(4)SV1(2)

Removed from this document.

Configuration limits

Added configuration limits for vEthernet interfaces, vEthernet trunks, port profiles, system profiles, and PVLANs.

4.0(4)SV1(2)

Appendix A, "Port Profile Configuration Limits"

vPC-Host Mode

Support for the following:

Manual creation of subgroups.

Connecting to upstream switches that do not support port channels using MAC Pinning.

4.0(4)SV1(2)

Chapter 5, "Configuring Port Channels in Port Profiles"

MAC Pinning

Connecting to upstream switches that do not support port channels using the MAC-pinning command.

4.0(4)SV1(2)

Chapter 5, "Configuring Port Channels in Port Profiles"

Static Pinning

Support for pinning or directing traffic for a vEthernet interface, control VLAN, or packet VLAN to a specific port channel subgroup.

4.0(4)SV1(2)

Chapter 5, "Configuring Port Channels in Port Profiles"

Port Profile Type

Creation of port-profiles includes the optional type field, which specifies the port profile as either Ethernet or vEthernet. By default, a port profiles is created as a vEthernet type.

4.0(4)SV1(2)

Chapter 2, "Creating Port Profiles"

[no] capability uplink command

The capability uplink command has been superseded by the port-profile [type {ethernet | vethernet}] name command. To configure a port profile with uplink capability, configure the port profile as an Ethernet type.

The no capability uplink command has been removed.

4.0(4)SV1(2)

Chapter 2, "Creating Port Profiles"

show running-config command

This command now shows the port profile type (Ethernet or vEthernet). Also, you can optionally specify to show only the port profile configurations.

4.0(4)SV1(2)

Chapter 7, "Verifying the Port Profile Configuration"

show port-profile name command

This command shows the port profile type and does not show the capability uplink. This command also shows the pinning and channel-group configuration.

4.0(4)SV1(2)

Chapter 7, "Verifying the Port Profile Configuration"