The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes how to configure the uplink type in the Cisco Nexus 1010 software and includes the following sections:
•Verifying the Uplink Configuration
Follow these guidelines and limitations when configuring uplinks in the Cisco Nexus 1010 software:
•A change to the uplink type does not take effect until you reload the software.
•Use Table 4-1 when modifying the uplink type.
Use this procedure to modify the uplink type on an operational Cisco Nexus 1010.
Before beginning this procedure, you must know or do the following:
•You are logged in to the CLI in EXEC mode.
•You must reload the Cisco Nexus 1010 pair in order to activate the changes made in this procedure.
•The following are supported uplink types and the ports that carry each type of VLAN traffic.
1. config t
2. network uplink type number
3. show network-uplink type
4. copy running-config startup-config
To verify the uplink configuration, use the following commands:
|
|
---|---|
show network-uplink type |
Displays the uplink configuration for verification. See Example 4-1 |
Example 4-1 Network Uplink Type
This example shows how to display the uplink configuration:
switch# show network uplink type
Administrative topology id: 2
Operational topology id: 1
switch#
For additional information related to implementing system-level HA features, see the following sections:
•MIBs
•RFCs
|
|
---|---|
Software setup configuration |
|
virtual service blade configuration |
|
Cisco Nexus 1010 installation |
Cisco Nexus 1010 Virtual Services Appliance Installation Guide |
Connecting uplinks |
Cisco Nexus 1010 Virtual Services Appliance Installation Guide |
Cisco Nexus 1010 commands |
Cisco Nexus 1010 Command Reference, Release 4.0(4)SP1(1) |
|
|
---|---|
No new or modified standards are supported by this feature, and support for existing standards has not been modified by this feature. |
— |
|
|
---|---|
No MIBs are supported by this feature |
— |
|
|
---|---|
No RFCs are supported by this feature |
— |
This section provides the uplink feature release history.
|
|
|
---|---|---|
Uplink |
4.0(4)SP1(1) |
This feature was introduced. |