J Commands
The commands in this chapter apply to the Cisco MDS 9000 Family of multilayer directors and fabric switches. All commands are shown here in alphabetical order regardless of command mode. See "About the CLI Command Modes" section on page 1-3 to determine the appropriate mode for each command.
job name
To assign a job to a command schedule, use the job name command. To remove the job, use the no form of the command.
job name job-name
no job name job-name
Syntax Description
job-name |
Specifies the job name for the command schedule to run. |
Defaults
None.
Command Modes
Scheduler schedule configuration submode.
Command History
|
|
2.0(x) |
This command was introduced. |
Usage Guidelines
To use this command, the command scheduler must be enabled using the scheduler enable command.
You can configure multiple jobs in a command schedule.
Examples
The following example shows how to specified the job for a command schedule:
switch(config)# scheduler schedule name MySchedule
switch(config-schedule)# job name MyJob
Related Commands
|
|
scheduler enable |
Enables the command scheduler. |
scheduler schedule name |
Configures a schedule for the command scheduler. |
show scheduler |
Displays scheduler information. |