Cisco SN 5420 Storage Router Hardware Installation Guide
Appendix A SN 5420 Storage Router Specifications
Downloads: This chapterpdf (PDF - 165.0KB) The complete bookPDF (PDF - 1.26MB) | Feedback

SN 5420 Storage Router Specifications

Table Of Contents

SN 5420 Storage Router Specifications

Chassis Specifications

Regulatory Standards Compliance

EMC Environmental Conditions for Product to be Installed in the European Union

(FCC) Class A Warning

Canada Class A Warning

(CISPR 22) Class A Warning

Japan (VCCI) Class A Warning

Taiwan (BSMI) Class A Warning

Hungarian Class A Warning


SN 5420 Storage Router Specifications


This appendix provides chassis specifications and regulatory compliance standards information for the SN 5420 storage router. The appendix includes the following sections:

Chassis Specifications

Regulatory Standards Compliance

Chassis Specifications

Table A-1 describes the chassis specifications for the SN 5420 storage router.

Table A-1 SN 5420 Storage Router Chassis Specifications

Specification
Description
Environmental
 

Temperature, ambient operating

32 to 104°F (0 to 40°C)

Temperature, ambient nonoperating and storage

-40 to 185°F (-40 to 85°C)

Humidity (RH), ambient (non-condensing) operating

10 to 95 percent non-condensing

Humidity (RH), ambient (noncondensing) nonoperating and storage

10 to 95 percent non-condensing

Altitude, operating and nonoperating

-500 to 10,000 ft (-152.4 to 3,048 m)

Physical Characteristics
 

Dimensions (H x W x D)

1.75 x 17 x 15.5 in. (4.4 x 43.2 x 39.4 cm)
1 RUs1 in height

Weight

7.5 lb (3.4 kg)

AC Power
 

Power supply output

70W

System power dissipation

35W

AC current

1.0A maximum @ 100 to 120 VAC
0.5A maximum @ 200 to 240 VAC

AC frequency

50 to 60 Hz

Airflow

Right and left side in, rear out

Power Supply
 

Fuse (F1) rating

1A, 250 VAC, time delay

1 RU = rack unit


Regulatory Standards Compliance

The SN 5420 storage router complies with the standards listed in Table A-2. See the following sections for EMC notices and warnings:

EMC Environmental Conditions for Product to be Installed in the European Union

(FCC) Class A Warning

Canada Class A Warning

(CISPR 22) Class A Warning

Japan (VCCI) Class A Warning

Taiwan (BSMI) Class A Warning

Hungarian Class A Warning

Table A-2 SN 5420 Storage Router Regulatory Standards Compliance

Item
Description

Regulatory Compliance

Products bear CE Marking indicating compliance with the (89/366/EEC, 73/23/EEC) directives, which includes the following safety and EMC standards.

Safety

UL 609501

CAN/CSA-C22.2 No. 9502

EN 609503

IEC 609504

TS 0015

AS/NZS 32606

EMC7

FCC (CFR 47, part 15) Class A8 , 9

EN 55022 Class A with UTP10 cabling

EN 55022 Class B with FTP11 cabling

CISPR 2212 Class A with UTP cabling

CISPR 22 Class B with FTP cabling

AS/NZS 354813 Class A with UTP cabling

AS/NZS 3548 Class B with FTP cabling

VCCI14 Class A with UTP cabling

VCCI Class B with FTP cabling

EN 55024

EN 50082-1

ICES 003 Class A

ETS 300 386-215

1 UL = Underwriters Laboratories

2 CSA = Canadian Standards Association

3 EN = European Norm

4 IEC = International Electrotechnical Commission

5 Technical Standard (Australian Communications Authority)

6 AS/NZS = Australia/New Zealand Standards

7 EMC = electromagnetic interference compatibility

8 FCC = Federal Communications Commission

9 CFR = Code of Federal Regulations

10 UTP = unshielded twisted-pair

11 FTP = foil-screened twisted pair

12 CISPR = Comite Internations Special Des Perturbations Radioelectrigues

13 AS/NZS = Australia/New Zealand Standards

14 VCCI = Voluntary Control Council for Information Technology Equipment - Japan Standard

15 ETS = European Telecommunications Standards


EMC Environmental Conditions for Product to be Installed in the European Union

This equipment is intended to operate under the following environmental conditions with respect to EMC:

1. A separate defined location under user's control.

2. Earthing and bonding shall meet the requirements of ETS 300 253 or CCITT K27.

3. Where applicable, AC power distribution shall be one of the following types: TN-S and TN-C [as defined in IEC 364-3]

In addition, if equipment is operated in a domestic environment, interference may occur.

(FCC) Class A Warning

Modifying the equipment without Cisco's authorization may result in the equipment no longer complying with FCC requirements for Class A or Class B digital devices. In that event, your right to use the equipment may be limited by FCC regulations, and you may be required to correct any interference to radio or television communications at your own expense.

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Canada Class A Warning

This Class 'A' digital apparatus complies with Canadian ICES-003.

Cet appareil numerique de la classe 'A' est conforme á la norme NMB-003 de Canada.

(CISPR 22) Class A Warning

This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Japan (VCCI) Class A Warning

Translation

This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.

Taiwan (BSMI) Class A Warning

Translation

This is a Class A Information Product, when used in residential environment, it may cause radio frequency interference, under such circumstances, the user may be requested to take appropriate countermeasures.

Hungarian Class A Warning

Figyelmeztetés a felhasználói kézikönyv számára: Ez a berendezés "A" osztályú termék, felhasználására és üzembe helyezésére a magyar EMC "A" osztályú követelményeknek (MSZ EN 55022) megfeleloen kerülhet sor, illetve ezen "A" osztályú berendezések csak megfelelo kereskedelmi forrásból származhatnak, amelyek biztosítják a megfelelo speciális üzembe helyezési körülményeket és biztonságos üzemelési távolságok alkalmazását.

Translation

This equipment is a class A product and should be used and installed properly according to the Hungarian EMC Class A requirements (MSZEN55022), the Class A equipment are derived for typical commercial establishments for which special conditions of installation and protection distance are used.