The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
Revised: May 26, 2017, OL-25998-01
This guide describes how you can configure and maintain the Cisco Identity Services Engine (ISE) Release 1.0, by using the command-line interface (CLI). Each topic provides a high-level summary of the tasks required for using the CLI for the Cisco ISE in the Cisco Application Deployment Engine (ADE) OS Release 2.0, that runs on supported appliances for small, medium, and large Cisco ISE deployments.
Note Use this guide in conjunction with the documentation listed in Related Documentation.
The majority of the instructions in this guide are straightforward; however, a few are complex. Therefore, only experienced users should use these instructions.
Note Use this guide in conjunction with the documentation listed in Related Documentation.
Cisco makes the following recommendations for using this document:
This table lists the major sections of this guide.
|
|
|
---|---|---|
Provides an overview of the Cisco ISE CLI environment and command modes. |
||
Describes how you can access and administer Cisco ISE from the CLI. |
||
This guide uses the following conventions to convey instructions and information.
Note Means reader take note. Notes identify important information that you should think about before continuing, contain helpful suggestions, or provide references to material not covered in the manual.
Tip Means the following information will help you solve a problem. A tip might not consist of an action or troubleshooting help, but could still contain useful information.
|
|
---|---|
Content updates for Cisco Identity Services Engine Maintenance Release 1.0.4.573: |
|
Republished with the following enhancements to coincide with Cisco Identity Services Engine Maintenance Release 1.0.4:
|
|
Table 2 lists the product documentation available for the Cisco ISE Release. General product information for Cisco ISE is available at http://www.cisco.com/go/ise. End-user documentation is available on Cisco.com at http://www.cisco.com/en/US/products/ps11640/tsd_products_support_series_home.html.
|
|
---|---|
Release Notes for the Cisco Identity Services Engine, Release 1.0.4 |
http://www.cisco.com/en/US/products/ps11640/prod_release_notes_list.html |
Cisco Identity Services Engine Network Component Compatibility, Release 1.0.4 |
http://www.cisco.com/en/US/products/ps11640/products_device_support_tables_list.html |
http://www.cisco.com/en/US/products/ps11640/products_user_guide_list.html |
|
Cisco Identity Services Engine Hardware Installation Guide, Release 1.0.4 |
http://www.cisco.com/en/US/products/ps11640/prod_installation_guides_list.html |
Cisco Identity Services Engine Migration Guide for Cisco Secure ACS 5.1 and 5.2, Release 1.0.4 |
http://www.cisco.com/en/US/products/ps11640/prod_installation_guides_list.html |
Cisco Identity Services Engine Sponsor Portal User Guide, Release 1.0.4 |
http://www.cisco.com/en/US/products/ps11640/products_user_guide_list.html |
Cisco Identity Services Engine CLI Reference Guide, Release 1.0.4 |
http://www.cisco.com/en/US/products/ps11640/prod_command_reference_list.html |
Cisco Identity Services Engine API Reference Guide, Release 1.0.4 |
http://www.cisco.com/en/US/products/ps11640/prod_command_reference_list.html |
Cisco Identity Services Engine Troubleshooting Guide, Release 1.0.4 |
http://www.cisco.com/en/US/products/ps11640/prod_troubleshooting_guides_list.html |
Regulatory Compliance and Safety Information for Cisco Identity Services Engine, Cisco 1121 Secure Access Control System, Cisco NAC Appliance, Cisco NAC Guest Server, and Cisco NAC Profiler |
http://www.cisco.com/en/US/products/ps11640/prod_installation_guides_list.html |
Cisco Identity Services Engine In-Box Documentation and China RoHS Pointer Card |
http://www.cisco.com/en/US/products/ps11640/products_documentation_roadmaps_list.html |
Links to Policy Management Business Unit documentation are available on www.cisco.com at the following locations:
The following notices pertain to this software license.
This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit ( http://www.openssl.org/).
This product includes cryptographic software written by Eric Young (eay@cryptsoft.com).
This product includes software written by Tim Hudson (tjh@cryptsoft.com).
The OpenSSL toolkit stays under a dual license, i.e. both the conditions of the OpenSSL License and the original SSLeay license apply to the toolkit. See below for the actual license texts. Actually both licenses are BSD-style Open Source licenses. In case of any license issues related to OpenSSL please contact openssl-core@openssl.org.
Copyright © 1998-2007 The OpenSSL Project. All rights reserved.
Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met:
1. Redistributions of source code must retain the copyright notice, this list of conditions and the following disclaimer.
2. Redistributions in binary form must reproduce the above copyright notice, this list of conditions, and the following disclaimer in the documentation and/or other materials provided with the distribution.
3. All advertising materials mentioning features or use of this software must display the following acknowledgment: “This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit ( http://www.openssl.org/)”.
4. The names “OpenSSL Toolkit” and “OpenSSL Project” must not be used to endorse or promote products derived from this software without prior written permission. For written permission, please contact openssl-core@openssl.org.
5. Products derived from this software may not be called “OpenSSL” nor may “OpenSSL” appear in their names without prior written permission of the OpenSSL Project.
6. Redistributions of any form whatsoever must retain the following acknowledgment:
“This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit ( http://www.openssl.org/)”.
THIS SOFTWARE IS PROVIDED BY THE OpenSSL PROJECT “AS IS”' AND ANY EXPRESSED OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE OpenSSL PROJECT OR ITS CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
This product includes cryptographic software written by Eric Young (eay@cryptsoft.com). This product includes software written by Tim Hudson (tjh@cryptsoft.com).
Copyright © 1995-1998 Eric Young (eay@cryptsoft.com). All rights reserved.
This package is an SSL implementation written by Eric Young (eay@cryptsoft.com).
The implementation was written so as to conform with Netscapes SSL.
This library is free for commercial and non-commercial use as long as the following conditions are adhered to. The following conditions apply to all code found in this distribution, be it the RC4, RSA, lhash, DES, etc., code; not just the SSL code. The SSL documentation included with this distribution is covered by the same copyright terms except that the holder is Tim Hudson (tjh@cryptsoft.com).
Copyright remains Eric Young’s, and as such any Copyright notices in the code are not to be removed. If this package is used in a product, Eric Young should be given attribution as the author of the parts of the library used. This can be in the form of a textual message at program startup or in documentation (online or textual) provided with the package.
Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met:
1. Redistributions of source code must retain the copyright notice, this list of conditions and the following disclaimer.
2. Redistributions in binary form must reproduce the above copyright notice, this list of conditions and the following disclaimer in the documentation and/or other materials provided with the distribution.
3. All advertising materials mentioning features or use of this software must display the following acknowledgement:
“This product includes cryptographic software written by Eric Young (eay@cryptsoft.com)”.
The word ‘cryptographic’ can be left out if the routines from the library being used are not cryptography-related.
4. If you include any Windows specific code (or a derivative thereof) from the apps directory (application code) you must include an acknowledgement: “This product includes software written by Tim Hudson (tjh@cryptsoft.com)”.
THIS SOFTWARE IS PROVIDED BY ERIC YOUNG “AS IS” AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
The license and distribution terms for any publicly available version or derivative of this code cannot be changed. i.e. this code cannot simply be copied and put under another distribution license [including the GNU Public License].
For information on obtaining documentation, submitting a service request, and gathering additional information, see the monthly What’s New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at:
http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html
Subscribe to the What’s New in Cisco Product Documentation as a Really Simple Syndication (RSS) feed and set content to be delivered directly to your desktop using a reader application. The RSS feeds are a free service and Cisco currently supports RSS Version 2.0.