Cisco CRS Carrier Routing System 16-Slot Line Card Chassis Enhanced Router Installation Guide
Installation Roadmap
Downloads: This chapterpdf (PDF - 175.0KB) The complete bookPDF (PDF - 49.82MB) | Feedback

Table of Contents

Overview of Chassis Installation Steps

Overview of Chassis Installation Steps

Table 1-1 lists the steps to install the chassis component and prepare the Cisco CRS Series Enhanced 16-Slot Line Card Chassis (LCC) for operation.Use the table as a checklist to ensure that all components are properly installed in the correct order. For information about a task, see the appropriate section of this installation guide.

 

Table 1-1 Overview of Installation Steps

Installation Steps
See
Check

1. Verify that the chassis is securely bolted to the floor.

Cisco CRS Series Enhanced 16-Slot Line Card Chassis Unpacking, Moving, and Securing Guide

2. Uncradle and install the upper power shelf bus bar.

“Installing the Power A Bus Bar” section

3. Remove the exhaust air deflector from the rear of the chassis.

“Removing the Exhaust Air Deflector” section

4. Ground the chassis.

“Installing the Chassis Ground Cable” section.

5. Install both AC or DC power shelves in the chassis.

“Installing an AC or DC Power Shelf” section.

6. Install AC cables or DC wiring on upper power shelf.

“Installing AC or DC Power Shelf Wiring” section.

7. Install AC cables or DC wiring on lower power shelf.

“Installing AC or DC Power Shelf Wiring” section.

8. Reinstall the exhaust air deflector.

“Installing the Exhaust Air Deflector” section

9. Install alarm modules in both power shelves.

“Installing an Alarm Module” section.

10. Install power modules in both power shelves.

“Installing a Power Module” section.

11. Power up the chassis and verify basic chassis operation.

“Power Up a Chassis” section.

12. Install default or optional external cosmetic components on the front (PLIM) side of the chassis.

“Installing the Front (PLIM) Side Exterior Cosmetic Components” section

13. Install external cosmetic components on the rear (MSC) side of the chassis.

“Installing the Rear (MSC) Side Cosmetic Components” section

14. Install line cards and PLIMs and route cables.

Chapter 6, “Installing Line Cards, PLIMs, and Associated Components”


Note For removal and replacement procedures, see Chapter7, “Removing Chassis Components”