Cisco CRS Carrier Routing System 16-Slot Line Card Chassis Enhanced Router Installation Guide
Preface
Downloads: This chapterpdf (PDF - 197.0KB) The complete bookPDF (PDF - 49.82MB) | Feedback

Table of Contents

Preface

Objective

Audience

Document Organization

Document Conventions

Related Documentation

Changes to This Document

Obtaining Documentation and Submitting a Service Request

Preface

This preface explains the objectives, intended audience, and organization of Cisco CRS Series Enhanced 16-Slot Line Card Chassis Installation Guide and describes the conventions that convey instructions and other information.

The preface contains the following sections:

Objective

This installation guide describes how to install components into and remove them from a line card chassis. This installation guide does not provide background information and basic theory-of-operation for anyone wanting to understand the Cisco CRS Series Enhanced 16-Slot Line Card Chassis.

Audience

This guide is intended for line card chassis installers and Cisco installation partners who are responsible for installing the Cisco CRS Series Enhanced 16-Slot Line Card Chassis components. The chassis installers are expected to have installed networking hardware in the past. No additional knowledge of routing or the Cisco IOS XR software is assumed.

Document Organization

This guide contains the following chapters and appendixes:

Document Conventions


Note Means reader take note. Notes contain helpful suggestions or references to materials not contained in this manual.



Timesaver Means the described action saves time. You can save time by performing the action described in the paragraph.



Caution Means reader be careful. You are capable of doing something that might result in equipment damage or loss of data.


Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents. To see translations of the warnings that appear in this publication, refer to the Regulatory Compliance and Safety Information document that accompanied this device. Statement 1074


Related Documentation

For complete planning, installation, and configuration information, refer to the following documents:

For a complete listing of software documentation available, refer to About Cisco IOS XR Software Documentation , available online at

http://cisco.com/en/US/products/ps5763/tsd_products_support_series_home.html

Changes to This Document

Table 1 lists the technical changes made to this document since it was first created.

 

Table 1 Changes to This Document

Revision
Date
Change Summary

OL-25576-05

July 2014

Added support for new 2x100GE-FLEX-40 PLIM.
Added updates to support the Cisco CRS-X 400G back-to-back and multishelf systems, which include new CRS-16-FC400/M switch fabric cards.

OL-25576-04

January 2014

Added updates to support the Cisco CRS-X, which includes new line cards, switch fabric cards, and PLIMs.

OL-25576-03

November 2013

Updates to procedures and illustrations.

OL-25576-02

May 2012

Updates to procedures, specifications, and illustrations.

OL-25576-01

October 2011

Initial release of the document

Obtaining Documentation and Submitting a Service Request

For information on obtaining documentation, submitting a service request, and gathering additional information, see the monthly What’s New in Cisco Product Documentation , which also lists all new and revised Cisco technical documentation, at:

http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html