Cisco ASR 903 Router Chassis Software Configuration Guide, IOS XE Release 3.10S
Configuring the Route Switch Processor
Downloads: This chapterpdf (PDF - 168.0KB) The complete bookPDF (PDF - 2.69MB) | Feedback

Table of Contents

Configuring the Route Switch Processor

Configuring Timing Ports

Configuring the Management Ethernet Port

Configuring Console Ports

Reloading the Route Switch Processor

Forcing a Route Switch Processor Switchover

Configuring the Route Switch Processor

This chapter describes how to configure the Route Switch Processor (RSP) on the Cisco ASR 900 Series Router and contains the following sections:

Configuring Timing Ports

For information about configuring timing ports on the RSP, see Chapter11, “Configuring Clocking and Timing”

Configuring the Management Ethernet Port

For information about configuring the management Ethernet port on the RSP, see Chapter3, “Using the Management Ethernet Interface”

Configuring Console Ports

For information about configuring console ports, see Chapter2, “Console Port, Telnet, and SSH Handling”

Reloading the Route Switch Processor

To reload the RSP, use the hw-module slot reload command in privileged EXEC mode.

Router# hw-module slot r0 reload
 

Forcing a Route Switch Processor Switchover

To force the standby RSP to assume the role of the active RSP, use the redundancy force-switchover command in privileged EXEC mode.

Router# redundancy force-switchover

Note The above task does not apply to Cisco ASR 902 router.