To use this
command, you must be in a user group associated with a task group that includes
the proper task IDs. If you suspect user group assignment is preventing you
from using a command, contact your AAA administrator for assistance.
When you use the
no form of
the command, accounting is disabled for both the source and destination. To
change accounting on either the destination or source address, reconfigure the
ipv4 bgp policy
accounting command specifying the
source-accounting keyword. In the following
example, you want BGP policy accounting disabled on the source address after
enabling source and destination address accounting earlier:
RP/0/RSP0/CPU0:router(config-if)# ipv4 bgp policy accounting output destination-accounting
Cisco ASR 9000 Series Aggregation Services Router
Routing Configuration Guide for information about configuring
a BGP policy. BGP accounting policy is based on community lists, autonomous
system numbers, or autonomous system paths.
For BGP policy
propagation to function, you must enable BGP.
To specify the
accounting policy, the proper route policy configuration must be in place,
matching specific BGP attributes using the
traffic-index command. In BGP router configuration mode, use the
command to modify the accounting buckets when the IP routing table is updated
with routes learned from BGP. To display accounting policy information, use the
This command is not
supported on ASR 9000 Ethernet Line Cards.