Cisco 7600 Series Cisco IOS Software Configuration Guide, 12.2SX
Configuring a Supervisor Engine 32
Downloads: This chapterpdf (PDF - 164.0KB) The complete bookPDF (PDF - 15.41MB) | Feedback

Configuring a Supervisor Engine 32

Table Of Contents

Configuring a Supervisor Engine 32

Flash Memory on a Supervisor Engine 32

Supervisor Engine 32 Ports


Configuring a Supervisor Engine 32


This chapter describes how to configure a Supervisor Engine 32 in a Cisco 7600 series router. This chapter contains these sections:

Flash Memory on a Supervisor Engine 32

Supervisor Engine 32 Ports


NoteFor complete syntax and usage information for the commands used in this chapter, refer to the Cisco IOS Master Command List, Release 12.2SX at this URL:

http://www.cisco.com/en/US/docs/ios/mcl/122sxmcl/12_2sx_mcl_book.html

With Cisco IOS software, this is the minimum required Supervisor Engine 32 memory:

512 MB DRAM on the Supervisor Engine 32

512 MB DRAM on the MSFC2A

Supervisor Engine 32 has a PFC3B and operates in PFC3B mode.

The Supervisor Engine 32 is supported in the WS-6503 and WS-6503-E (3-slot) chassis, but not the CISCO7603 chassis.

With a 3-slot or a 4-slot chassis, install the Supervisor Engine 32 in either slot 1 or 2.

With a 6-slot or a 9-slot chassis, install the Supervisor Engine 32 in either slot 5 or 6.

With a 13-slot chassis, install the Supervisor Engine 32 in either slot 7 or 8.

Supervisor Engine 32 does not support switch fabric connectivity.

For information about the hardware and software features supported by the Supervisor Engine 32, see the Release Notes for Cisco IOS Release 12.2SX on the Supervisor Engine 720, Supervisor Engine 32, and Supervisor Engine 2.



Tip For additional information (including configuration examples and troubleshooting information), see the documents listed on this page:

http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html


Flash Memory on a Supervisor Engine 32

The Supervisor Engine 32 supports the following flash memory:

disk0:—One external CompactFlash Type II slot (supports CompactFlash Type II Flash PC cards)

sup-bootdisk:—256 MB internal CompactFlash memory (from ROMMON, it is bootdisk:)

Supervisor Engine 32 Ports

The console port for the Supervisor Engine 32 port is an EIA/TIA-232 (RS-232) port. The Supervisor Engine 32 also has two Universal Serial Bus (USB) 2.0 ports that are not currently enabled.

WS-SUP32-GE-3B ports 1 through 8 have small form-factor pluggable (SFP) connectors and port 9 is a 10/100/1000 Mbps RJ-45 port.

WS-SUP32-10GE ports 1 and 2 are 10 Gigabit Ethernet ports that accept XENPAKs and port 3 is a 10/100/1000 Mbps RJ-45 port.


Tip For additional information (including configuration examples and troubleshooting information), see the documents listed on this page:

http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html