Cisco FlexWAN and Enhanced FlexWAN Modules Installation Guide
CLI Commands for the FlexWAN and Enhanced FlexWAN Modules
Downloads: This chapterpdf (PDF - 341.0KB) The complete bookPDF (PDF - 957.0KB) | Feedback

CLI Commands for the FlexWAN and Enhanced FlexWAN Modules

Table Of Contents

CLI Commands for the FlexWAN and Enhanced FlexWAN Modules


CLI Commands for the FlexWAN and Enhanced FlexWAN Modules


Table 3-1 lists the CLI commands for displaying FlexWAN or Enhanced FlexWAN module status, configuration, and statistical information, as well as the commands for debugging purposes. Enter these commands from the Multilayer Switch Feature Card (MSFC) console.


Note For more information on these commands, see: http://www.cisco.com/en/US/docs/ios/mcl/122sxmcl/12_2sx_mcl_book.html


Table 3-1 CLI Commands for the FlexWAN and Enhanced FlexWAN Modules

Command
Options
Description

Router# show cwan

stats

vlans

Displays WAN port statistics.

Displays hidden VLAN-to-WAN interface mapping.

Router# dir cwan

cwan[mod_num]/bay-bootflash:

cwan[mod_num]/bay-disk0

Displays the FlexWAN module bootflash devices.

Displays the Enhanced FlexWAN module bootflash devices.

Router# show fabric

switching-mode

utilization

Displays the module switching mode.

Displays the percentage of utilization for each fabric channel.

Router# show diagnostic

bootup level

content

events

schedule

Displays the coverage level for the boot-up diagnostics.

Displays test information for each test and for all modules.

Displays the event log for the diagnostic events.

Displays the current scheduled diagnostic tasks.