Cisco ONS SDH TL1 Command Guide, Release 9.4
Chapter 2, APPLY Commands
Downloads: This chapterpdf (PDF - 310.0 KB) The complete bookPDF (PDF - 10.92 MB) | Feedback

Table of Contents

APPLY Commands


APPLY Commands

This chapter provides apply (APPLY) commands for the Cisco ONS 15454 SDH, Cisco ONS 15454 M2, and Cisco ONS 15454 M6.

NoteAll commands supported on the Cisco ONS 15454 SDH platform are also supported on Cisco ONS 15454 M2 and Cisco ONS 15454 M6 platforms.


(Cisco ONS 15454 SDH) The Apply (APPLY) command activates or reverts a software load during a software upgrade or downgrade process.

Usage Guidelines

An error will be generated if you attempt to activate an older software load or attempt to revert to a newer software load.


File Transfer



Input Format


Input Example


Table 2-1 APPLY Commands - Parameter Support

Input Parameters


(Optional) Memory switch action during the software upgrade. The parameter type is DL_TYPE, which indicates the software download type. The default value is ACT.

  • ACPT

Activates to a newer software load on the active controller card and resets the active card.

  • CANC

Cancels the software download.

  • RVRT

Reverts to an older software load during software download.

  • ACT

Activates to a new software load.