Cisco ONS SDH TL1 Command Guide, R9.1
Chapter 2, APPLY Commands
Downloads: This chapterpdf (PDF - 315.0KB) The complete bookPDF (PDF - 19.83MB) | Feedback

APPLY Commands

Table Of Contents

APPLY Commands

2.1  APPLY


APPLY Commands


This chapter provides apply (APPLY) commands for the Cisco ONS 15310-MA SDH, Cisco ONS 15454 SDH, and Cisco ONS 15600 SDH.

2.1  APPLY

(Cisco ONS 15310-MA SDH, Cisco ONS 15454 SDH, and Cisco ONS 15600 SDH) The Apply (APPLY) command activates or reverts a software load during a software upgrade or downgrade process.

Usage Guidelines

An error will be generated if you attempt to activate an older software load or attempt to revert to a newer software load.

Category

File Transfer

Security

Superuser

Input Format

APPLY:[<TID>]::<CTAG>[::<MEM_SW_TYPE>];

Input Example

APPLY:CISCO::123::ACT;

Table 2-1 APPLY Commands - Parameter Support

Input Parameters
Description
ONS 15454 SDH
ONS 15600 SDH
ONS 15310-MA SDH

<MEM_SW_TYPE>

(Optional) Memory switch action during the software upgrade. The parameter type is DL_TYPE, which indicates the software download type. The default value is ACT.

Y

Y

Y

ACPT

(ONS 15600) Activates to a newer software load on the active controller card and resets the active card.

N

Y

N

CANC

(ONS 15600) Cancels the software download.

N

Y

N

RVRT

Reverts to an older software load during software download.

Y

N

Y

ACT

Activates to a new software load. (For ONS 15600, the new software load is activated on the standby controller card only).

Y

Y

Y