Cisco ONS SDH TL1 Command Guide, Release 8.5
Chapter 3, APPLY Commands
Downloads: This chapterpdf (PDF - 309.0KB) The complete bookPDF (PDF - 14.48MB) | Feedback

APPLY Commands

Table Of Contents

APPLY Commands

3.1  APPLY


APPLY Commands


This chapter provides apply (APPLY) commands for the Cisco ONS 15454 SDH and
Cisco ONS 15600 SDH.

3.1  APPLY

(Cisco ONS 15454 SDH and ONS 15600 SDH) The Apply (APPLY) command activates or reverts a software load during a software upgrade or downgrade process.

Usage Guidelines

An error will be generated if you attempt to activate an older software load or attempt to revert to a newer software load.

Category

File Transfer

Security

Superuser

Input Format

APPLY:[<TID>]::<CTAG>[::<MEM_SW_TYPE>];

Input Example

APPLY:CISCO::123::ACT;

Input Parameters

<MEM_SW_TYPE>

(Optional) Memory switch action during the software upgrade. The parameter type is DL_TYPE, which indicates the software download type. The default value is ACT.

ACPT

(ONS 15600) Activates to a newer software load on the active controller card and resets the active card.

CANC

(ONS 15600) Cancels the software download.

RVRT

Reverts to an older software load during software download.

ACT

Activates to a new software load. (For ONS 15600, the new software load is activated on the standby controller card only).