The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes how you can start the command line interface (CLI) to access the Cisco Broadband Access Center (Cisco BAC) Device Provisioning Engine (DPE).
To access the DPE CLI, open a Telnet session to port 2323 from a local or remote host.
To access the CLI from a local host, you can use:
# telnet localhost 2323
or
# telnet 0 2323
To access the CLI from a remote host, enter:
# telnet remote-hostname 2323
Note If you cannot establish a Telnet connection to the CLI, it is likely that the CLI server is not running. You may need to start the server. To start the server, enter:
# /etc/init.d/bprAgent start cli
After you access the CLI, you must enter the DPE password to continue. The default login and enable passwords are changeme.
For information on how to change the login password and the enable password, see the password, and the enable password, commands, respectively.
bac_host# telnet 0 2323
Trying 0.0.0.0...
Connected to 0.
Escape character is '^]'.
bac_host BAC Device Provisioning Engine
User Access Verification
Password:
bac_host> enable
Password:
bac_host#