Cisco IOS XR Interface and Hardware Component Debug Command Reference, Release 3.5
802.1Q VLAN Debug Commands on Cisco IOS XR Software
Downloads: This chapterpdf (PDF - 37.0KB) The complete bookPDF (PDF - 2.19MB) | Feedback

802.1Q VLAN Debug Commands on Cisco IOS XR Software

Table Of Contents

802.1Q VLAN Debug Commands on Cisco IOS XR Software

debug snmp mib vlanifrelationmib


802.1Q VLAN Debug Commands on Cisco IOS XR Software


This chapter describes the commands used to 802.1Q VLAN subinterfaces on a router running Cisco IOS XR software.

debug snmp mib vlanifrelationmib

To turn on 802.1Q VLAN debugging, use the debug snmp mib vlanifrelationmib command in EXEC mode. To turn off 802.1Q VLAN debugging, use the no form of this command.

debug snmp mib vlanifrelationmib

no debug snmp mib vlanifrelationmib

Syntax Description

This command has no arguments or keywords.

Defaults

No default behavior or values

Command Modes

EXEC

Command History

Release
Modification

Release 3.5.0

This command was introduced on the Cisco CRS-1 and Cisco XR 12000 Series Router.


Usage Guidelines

To use this command, you must be in a user group associated with a task group that includes the proper task IDs. For detailed information about user groups and task IDs, see the Configuring AAA Services on Cisco IOS XR Software module of the Cisco IOS XR System Security Configuration Guide.

Debugging output is assigned high priority in the CPU process and, therefore, can affect system performance. For more information about the impact on system performance when using debug commands, refer to Using Debug Commands on Cisco IOS XR Software.

Task ID

Task ID
Operations

snmp

read, write


Examples

The following example shows how to turn on 802.1Q VLAN debugging:

RP/0/RP0/CPU0:router# debug snmp mib vlanifrelationmib