Cisco IOS XR System Error Reference Guide for XR12000 Series Platform Specific Messages, Release 3.4
Diagnostic Messages
Downloads: This chapterpdf (PDF - 310.0KB) The complete bookPDF (PDF - 2.64MB) | Feedback

Diagnostic Messages

Table Of Contents

Diagnostic Messages

PFDIAGBASE Messages


Diagnostic Messages


This section contains all Diagnostic related System Error Messages. The following facility codes are represented in this module:

PFDIAGBASE Messages

PFDIAGBASE Messages

Error Message     
 
    
    
   

%DIAG-PFDIAGBASE-3-INIT_ERROR [chars] ([hex] - [chars])

Explanation    An error occurred during initialization.

Recommended Action    Normally this message type indicates a transient error, and even though it will cause the process to be terminated, the problem will usually be remedied once the emitting process is restarted. If the error keeps occuring frequently then copy the error message exactly as it appears on the screen and gather any relevant information about the circumstances. Contact your technical support representative with the gathered information.

Error Message     
 
    
    
   

%DIAG-PFDIAGBASE-3-SW_ERROR [chars] ([hex] - [chars])

Explanation    An internal software error occurred.

Recommended Action    Copy the error message exactly as it appears on the screen and gather any relevant information about the circumstances. Contact your technical support representative with the gathered information.

Error Message     
 
    
    
   

%DIAG-PFDIAGBASE-4-WARNING [chars] ([hex] - [chars])

Explanation    Software detected an unexpected error or condition, which is not fatal to the features performance, but which may have affected a test result or similar.

Recommended Action    Take note of the message, to see if it may explain a later test failure or similar.