Cisco IOS XR System Error Reference Guide for CRS-1 Router Platform Specific Messages, Release 3.4
Fabric Messages
Downloads: This chapterpdf (PDF - 312.0KB) The complete bookPDF (PDF - 1.84MB) | Feedback

Fabric Messages

Table Of Contents

Fabric Messages

FEATURE_LPTS Messages


Fabric Messages


This section contains all Fabric (hardware and software both) related System Error Messages. The following facility codes are represented in this module:

FEATURE_LPTS Messages

FEATURE_LPTS Messages

Error Message     
 
    
    
   

%FABRIC-FEATURE_LPTS-3-ERR_DOUBLE_FREE Double free of FGID [dec]

Explanation    LPTS could not free the FGID successfully from its local DB. You may try restarting the lpts_pa process. If you continue to see these errors, your "hot-standby" application may not function as expected and may require that you contact TAC.

Recommended Action    You may try restarting the lpts_pa process. If you continue to see these errors, your "hot-standby" application may not function as expected & may require to contact TAC.

Error Message     
 
    
    
   

%FABRIC-FEATURE_LPTS-3-ERR_UNALLOCATED_FREE Attempt to free unallocated FGID [dec]

Explanation    LPTS could not free the FGID successfully from its local DB. You may try restarting the lpts_pa process. If you continue to see these errors, your "hot-standby" application may not function as expected & may require to contact TAC.

Recommended Action    You may try restarting the lpts_pa process. If you continue to see these errors, your "hot-standby" application may not function as expectedand may require that you contact TAC.

Error Message     
 
    
    
   

%FABRIC-FEATURE_LPTS-3-ERR_UNKNOWN_FGID_DB_ERROR Unknown error from FGID-DB, [chars] FGID [dec] id [dec]: [chars]

Explanation    LPTS could not interpret the results after the FGID operation. If you continue to see these errors, your "hot-standby" application may not function as expected and may require that you contact TAC.

Recommended Action    If you continue to see these errors, your "hot-standby" application may not function as expected & may require to contact TAC.