Cisco IOS XR Routing Debug Command Reference, Release 3.3
RIP Debug Commands on Cisco IOS XR Software
Downloads: This chapterpdf (PDF - 161.0KB) The complete bookPDF (PDF - 1.53MB) | Feedback

RIP Debug Commands on Cisco IOS XR Software

Table Of Contents

RIP Debug Commands on Cisco IOS XR Software

debug rip


RIP Debug Commands on Cisco IOS XR Software


This chapter describes the commands used to debug the Routing Information Protocol (RIP) on
Cisco IOS XR software.

debug rip

To display debugging information for the Routing Information Protocol (RIP), use the debug rip command in EXEC mode. To disable debugging output, use the no form of this command.

debug rip {auth | database | events | global | im | oom | policy | receive | rib | send | show} [interface type instance| vrf [all | vrf-name]]

no debug rip {auth | database | events | global | im | oom | policy | receive | rib | send | show} [interface type instance | vrf [all | vrf-name]]

Syntax Description

auth

Displays RIP autentication information.

database

Displays RIP database events.

events

Displays RIP protocol events.

global

Displays RIP global messages.

im

Displays RIP vrf and interface events.

oom

Displays RIP out of memory information.

policy

Displays RIP policy run information.

receive

Displays RIP packet receive information

rib

Displays the interaction of RIP with the Routing Information Base (RIB).

send

Displays RIP packet send information.

show

Displays the show command output for RIP.

interface

(Optional)Specifies an interface to filter.

type

Interface type. For more information, use the question mark (?) online help function.

instance

Either a physical interface instance or a virtual interface instance as follows:

Physical interface instance. Naming notation is rack/slot/module/port and a slash between values is required as part of the notation.

rack: Chassis number of the rack.

slot: Physical slot number of the modular services card or line card.

module: Module number. A physical layer interface module (PLIM) is always 0.

port: Physical port number of the interface.

Virtual interface instance. Number range varies depending on interface type.

For more information about the syntax for the router, use the question mark (?) online help function.

vrf

(Optional) Specifies a VPN Routing and Forwarding (VRF) instance to filter.

vrf-name

(Optional) Name of the VRF instance to be filtered.

all

(Optional) selects all VRF instances.


Defaults

Debugging is disabled.

Command Modes

EXEC

Command History

Release
Modification

Release 3.3.0

This command was introduced on the Cisco CRS-1 and Cisco XR 12000 Series Router.


Usage Guidelines

To use this command, you must be in a user group associated with a task group that includes the proper task IDs. For detailed information about user groups and task IDs, see the Configuring AAA Services on Cisco IOS XR Software module of the Cisco IOS XR System Security Configuration Guide.

Debugging output is assigned high priority in the CPU process and, therefore, can affect system performance. For more information about the impact on system performance when using debug commands, refer to Using Debug Commands on Cisco IOS XR Software.


Caution The debug rip command generates a substantial amount of output. Use the command only when traffic on the IP network is low so that other activity on the system is not adversely affected.

Task ID

Task ID
Operations

rip

read


Examples

The following example shows how to enable debugging information about RIP:

RP/0/RP0/CPU0:router# debug rip

Related Commands

Command
Description

undebug

Enters debug mode to disable or reset multiple active debug command sessions.