This documentation has been moved
Wireless LAN Error Messages
Downloads: This chapterpdf (PDF - 114.0KB) The complete bookPDF (PDF - 2.0MB) | Feedback

Wireless LAN Error Messages

Table Of Contents

Wireless LAN Error Messages

Contents

Information About Wireless LAN Error Messages

Association Management Messages

802.11 Subsystem Messages

Local Authenticator Messages

Additional References

Related Documents

Technical Assistance


Wireless LAN Error Messages


This module lists wireless LAN (WLAN) error messages for the Cisco 800, 1800, 2800, and 3800 series integrated services routers, hereafter referred to as an access point or AP.

Module History

This module was first published on December 15, 2005.

Contents

Information About Wireless LAN Error Messages

Additional References

Information About Wireless LAN Error Messages

This section contains the following subsections:

Association Management Messages

802.11 Subsystem Messages

Local Authenticator Messages

Association Management Messages

Error Message    
DOT11-3-BADSTATE: [mac-address] [chars] [chars] -> [chars]

Explanation    802.11 Association and management uses a table-driven state machine to track and transition an association through various states. A state transition occurs when an association receives one of many possible events. When this error occurs, it means that an association received an event that it did not expect while in this state.

Recommended Action    The system can continue but may lose the association that generates this error. Copy the message exactly as it appears and report it to your technical service representative.

Error Message    
DOT11-6-ASSOC: Interface [interface], Station [char] [mac] Associated

Explanation    A station associated to an access point.

Recommended Action    None.

Error Message    
DOT11-6-ADD: Interface [interface], Station [mac] Associated to Parent [mac]

Explanation    A station associated to an access point.

Recommended Action    None.

Error Message    
DOT11-6-DISASSOC: Interface [interface], Deauthenticating Station [mac] [char]

Explanation    A station disassociated from an access point.

Recommended Action    None.

802.11 Subsystem Messages

Error Message    
DOT11-6-FREQ_INUSE: Radio frequency [int] is in use

Explanation    When scanning for an unused frequency, the unit recognized another radio using the displayed frequency.

Recommended Action    None.

Error Message    
DOT11-6-FREQ_USED: Radio frequency [int] selected

Explanation    After scanning for an unused frequency, the unit selected the displayed frequency.

Recommended Action    None.

Error Message    
DOT11-4-NO_SSID: No SSIDs configured, radio not started

Explanation    All Service Set Identifiers (SSIDs) were deleted from the configuration. At least one must be configured for the radio to run.

Recommended Action    Configure at least one SSID on the access point.

Error Message    
DOT11-2-RADIO_FAILED: Interface [interface] failed — [chars]

Explanation    The radio driver found a severe error and is shutting down.

Recommended Action    None.

Error Message    
DOT11-4-CANT_ASSOC: Cannot associate: [chars]

Explanation    The unit could not establish a connection to a parent access point for the displayed reason.

Recommended Action    Verify that the basic configuration settings (SSID, Wired Equivalent Privacy [WEP], and others) of the parent access point and this unit match.

Error Message    
DOT11-4-MAXRETRIES: Packet to client [mac] reached max retries, remove the client

Explanation    Delivery of a packet sent to the client failed many times, and the maximum retries limit has been reached. The client is deleted from the association table.

Recommended Action    None.

Error Message    
DOT11-AUTH_FAILED: Station [mac-address] authentication failed

Explanation    The station failed authentication.

Recommended Action    Verify that the user entered the correct username and password, and check that the authentication server is online.

Error Message    
DOT11-TKIP_MIC_FAILURE: TKIP Michael MIC failure was detected on a packet (TSC=0x0) received from [mac-address]

Explanation    TKIP Michael MIC failure was detected on a unicast frame decrypted locally with the pairwise key.

Recommended Action    A failure of the Michael MIC in a packet usually indicates an active attack on your network. Search for and remove potential rogue devices from your wireless LAN.

Error Message    
DOT11-TKIP_MIC_FAILURE_REPORT: Received TKIP Michael MIC failure report from the station [mac-address] on the packet (TSC=0x0) encrypted and protected by [key] key

Explanation    The access point received an EAPOL-key from a station notifying the access point that TKIP Michael MIC failed on a packet sent by this access point.

Recommended Action    None.

Error Message    
DOT11-TKIP_MIC_FAILURE_REPEATED: Two TKIP Michael MIC failures were detected within [number] seconds on [interface] interface. The interface will be put on MIC failure hold state for next [number] seconds

Explanation    Because MIC failures usually indicate an active attack on your network, the interface will be put on hold for the configured time. During this hold time, stations using TKIP ciphers are disassociated and cannot reassociate until the hold time ends. At the end of the hold time, the interface operates normally.

Recommended Action    Michael MIC failures usually indicate an active attack on your network. Search for and remove potential rogue devices from your wireless LAN. If this is a false alarm and the interface should not be on hold this long, use the countermeasure tkip hold-time command to adjust the hold time.

Error Message    
Multicast received for AP sa [mac-address], da [mac-address], ra cbcb.cbcb.cbcb ta [mac-address]

Explanation    The access point received a direct broadcast or multicast frame in which the dot11 MAC header's RA address field is a broadcast or multicast address.

Recommended Action    None. However, if your access point displays this message frequently, capture these frames with a sniffer for further analysis.

Local Authenticator Messages

Error Message    
RADSRV-4-NAS_UNKNOWN: Unknown authenticator: [ip-address]

Explanation    The local RADIUS server received an authentication request but does not recognize the IP address of the network access server (NAS) that forwarded the request.

Recommended Action    Make sure that every access point on your wireless LAN is configured as a NAS on your local RADIUS server.

Additional References

The following sections provide references related to error and event messages.

Related Documents

Related Topic
Document Title

Cisco IOS wireless LAN commands: complete command syntax, command mode, command history, defaults, usage guidelines, and examples

Cisco IOS Wireless LAN Command Reference


Technical Assistance

Description
Link

The Cisco Technical Support website contains thousands of pages of searchable technical content, including links to products, technologies, solutions, technical tips, and tools. Registered Cisco.com users can log in from this page to access even more content.

http://www.cisco.com/techsupport