Security Configuration Guide: Threat Information Distribution Protocol and TMS Cisco IOS Release 15.1M&T
End of Life of TIDP and TMS
Downloads: This chapterpdf (PDF - 115.0KB) | Feedback

End of Life of TIDP and TMS

Table Of Contents

End of Life of TIDP and TMS

Finding Feature Information

Removal of Support for TIDP and TMS Commands

Feature Information for End of Life TIDP and TMS


End of Life of TIDP and TMS


First Published: May 5, 2010
Last Updated: May 5, 2010

Support for Threat Information Distribution Protocol (TIDP) and TIDP Based Mitigation Services (TMS) features and commands has been removed in Cisco IOS Release 12.4(20)T and later releases. This change marks the end of life for TIDP and TMS.

Finding Feature Information

Your software release may not support all the features documented in this module. For the latest feature information and caveats, see the release notes for your platform and software release. To find information about the features documented in this module, and to see a list of the releases in which each feature is supported, see the "Feature Information for End of Life TIDP and TMS" section.

Use Cisco Feature Navigator to find information about platform support and Cisco software image support. To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not required.

Removal of Support for TIDP and TMS Commands

The following commands have been removed from the Cisco IOS:

acl drop

active

authentication-key receive

authentication-key send

class-map type mitigation

class-map type tms

clear tms consumer group

clear tidp counters

controller (TMS)

debug tidp

debug tms consumer

debug tms controller

encryption-key receive

encryption-key send

exception access-group

heartbeat retry count

heartbeat retry interval

identifier

ignore (TMS)

key-set

logging tms events

match primitive

match priority

match tidp-group

message retry count

message retry interval

mitigation

parameter-map type mitigation

parameter-map type tms

peer

policy-map type control mitigation

policy-map type control tms

redirect route

registration retry count

registration retry interval

show tidp

show tidp group

show tidp key-set

show tidp peer

show tms consumer

show tms consumer group

show tms controller

show tms controller group

service-policy type tms

source parameter

test tidp

tidp enable

tidp group

tidp key-set

tidp source

tms consumer

tms consumer deregister

tms consumer register

tms consumer resync

tms controller

tms controller deregister

tms controller load threat

tms controller reset

tms controller send

tms controller status

tms controller unload

tms-class

variable

Feature Information for End of Life TIDP and TMS

Table 1 lists the features in this module and provides links to specific configuration information.

Use Cisco Feature Navigator to find information about platform support and software image support. Cisco Feature Navigator enables you to determine which software images support a specific software release, feature set, or platform. To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not required.


Note Table 1 lists only the software release that introduced support for a given feature in a given software release train. Unless noted otherwise, subsequent releases of that software release train also support that feature.


Table 1 Feature Information for End of Life TIDP and TMS 

Feature Name
Releases
Feature Information

End of Life TIDP and TMS

12.4(20)T

Support for Threat Information Distribution Protocol (TIDP) and TIDP Based Mitigation Services (TMS) features and commands has been removed in Cisco IOS Release 12.4(20)T and later releases. This change marks the end of life for TIDP and TMS.


Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any examples, command display output, network topology diagrams, and other figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses or phone numbers in illustrative content is unintentional and coincidental
© 2010 Cisco Systems, Inc. All rights reserved.