Cisco IOS Mobile Wireless Radio Access Networking Command Reference
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
- Updated:
- September 22, 2008
Book Table of Contents
Notes
This document contains Cisco IOS commands that are supported in many different software releasesand on many different platforms. Some of the commands that are included in this document may not besupported in your Cisco IOS software release.
Any Internet Protocol (IP) addresses used in thisdocument are not intended to be actual addresses. Any examples, command display output, and figuresincluded in the document are shown for illustrative purposes only. Any use of actual IP addressesin illustrative content is unintentional and coincidental.
Recommended Reading:
About Cisco IOS SoftwareDocumentation
Using theCommand-Line Interface in Cisco IOS Software Suggest ways Cisco technical documentation can be improved and better serve your needs.
Participate in the Technical Documentation Ideas forum.
Participate in the Technical Documentation Ideas forum.
Feedback