Feature Information for Cisco UBE (Enterprise) Fundamentals and Basic Setup

Table Of Contents

Feature Information for Cisco UBE (Enterprise) Fundamentals and Basic Setup

Feature Information for Cisco UBE (Enterprise) Fundamentals and Basic Setup

Table 1 lists the release history for this chapter.

Use Cisco Feature Navigator to find information about platform support and software image support. Cisco Feature Navigator enables you to determine which software images support a specific software release, feature set, or platform. To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not required.

---

Note Table 1 lists only the Cisco IOS software release that introduced support for a given feature in a given software release train. Unless noted otherwise, subsequent releases of that software release train also support that feature.

---

Table 1 Feature Information for Cisco UBE (Enterprise) Fundamentals and Basic Setup Features 

Feature Name	Releases	Feature Information
"SIP—Gateway Support for the bind Command"	Cisco IOS XE Release 2.5	This features allows you to configure the source IP address of signaling packets, or configure both signaling and media packets. The following commands were introduced or modified: bind and sip.
SIP-to-SIP Basic Functionality	Cisco IOS XE Release 2.5	This feature provides termination and reorigination of both signaling and media between VoIP and video networks using SIP signaling in conformance with RFC3261. The following commands were introduced or modified: allow-connections
Transport Control Protocol (TCP) and User Datagram Protocol (UDP) interworking	Cisco IOS XE Release 3.1S	The SIP-to-SIP Extended Feature Functionality for Session Border Controllers (SBCs) enables the SIP-to-SIP functionality to conform with RFC 3261 to interoperate with SIP User Agents (UAs). This feature uses no new or modified commands.
Cisco Unified Border Element and Cisco Unified Communications Manager Express Support for Universal Packaging	15.0(1)M	This introduces the mode border-element command to distinguish between Cisco Unified Communications Manager Express and Cisco UBE configuration. The following command was introduced: mode border-element.
Configuring an Inbound Dial-peer to Match the URI on SIP Calls	Cisco IOS XE Release 3.1S	Expands the inbound dial-peer matching logic to include matching based on the source IP address of inbound signaling on a SIP trunk.

Cisco and the Cisco Logo are trademarks of Cisco Systems, Inc. and/or its affiliates in the U.S. and other countries. A listing of Cisco's trademarks can be found at www.cisco.com/go/trademarks. Third party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1005R)

Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.

© 2011 Cisco Systems, Inc. All rights reserved.