Guest

Networking Software (IOS & NX-OS)

Cisco Unified Communication Trusted Firewall Control-Version II

  • Viewing Options

  • PDF (32.1 KB)
  • Feedback
Cisco Unified Communication Trusted Firewall Control-Version II

Table Of Contents

Cisco Unified Communication Trusted Firewall Control-Version II

Prerequisites for Cisco Unified Communication Trusted Firewall Control-Version II

Configuring Cisco Unified Communication Trusted Firewall Control-Version II


Cisco Unified Communication Trusted Firewall Control-Version II

Cisco Unified Communications Trusted Firewall Control pushes intelligent services onto the network through a Trusted Relay Point (TRP) firewall. TRP is a Cisco IOS service feature, which is similar to the Resource Reservation Protocol (RSVP) agent. Firewall traversal is accomplished using Session Traversal Utilities for NAT (STUN) on a TRP colocated with a Cisco Unified Communications Manager Express (Cisco Unified CME), Cisco Unified Border Element, and Media Termination Points (MTP).

This release introduces the following features:

Noncolocated firewall for UC SIP trunks

Support Firewall traversal for Cisco Unified Border Element call flows in which the media flow through the Media Termination Points such as MTP, Transcoder, or Conference bridge with Trust Relay Point (TRP) enabled.

Firewall traversal for additional Cisco Unified Border Element call flows using STUN.

Prerequisites for Cisco Unified Communication Trusted Firewall Control-Version II

Cisco Unified Border Element

Cisco IOS Release 15.0(1)T or a later release must be installed and running on your Cisco Unified Border Element.

Cisco Unified Border Element (Enterprise)

Cisco IOS XE Release 3.3S or a later release must be installed and running on your Cisco ASR 1000 Series Router.

Configuring Cisco Unified Communication Trusted Firewall Control-Version II

To enable this feature, see the "Cisco Unified Communications Trusted Firewall Control-Version II" feature guide.

Detailed command information for the stun flowdata catlife command is located in the Cisco IOS Voice Command Reference.