Cisco IOS Bridging Command Reference
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
- Updated:
- October 15, 2007
Book Table of Contents
- access-expression through bridge-group subscriber-trunk
- rif through spanning-tree portfast (interface mode)
- Appendix: Ethernet Type Codes
Notes
This document contains Cisco IOS commands that are supported in many different software releases and on many different platforms. Some of the commands that are included in this document may not be supported in your Cisco IOS software release.
Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.
Recommended Reading:
Feedback