Table Of Contents
FHRP - HSRP Group Shutdown
The FHRP - HSRP Group Shutdown feature enables you to configure a Hot Standby Router Protocol (HSRP) group to become disabled (its state changed to Init) instead of having its priority decremented when a tracked object goes down.
Configuration information is included in the "Configuring HSRP" module in the Cisco IOS IP Application Services Configuration Guide, Release 12.4T, at the following URL:
The following sections provide information about this feature:
•HSRP Group Shutdown
•Configuring HSRP Object Tracking
•HSRP Group Shutdown: Example
For a complete list of features included in the "Configuring HSRP" module, refer to the Feature Information Table located toward the end of the module.
Command Reference Information
Command reference information is included in the Cisco IOS IP Application Services Command Reference, Release 12.4T, at the following URL:
New or Modified Commands
The following commands are modified for this feature:
List of All Release 12.4T Commands
An alphabetical list of all Cisco IOS Release 12.4T commands is in the Cisco IOS Master Commands List, Release 12.4T, at the following URL:
List of All New, Modified, Removed, and Replaced Release 12.4T Commands
Alphabetized lists of all new, modified, removed, and replaced commands for each Cisco IOS Release 12.4T release are in the Cisco IOS New, Modified, Removed, and Replaced Commands, Release 12.4T, document at the following URL:
Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.
© 2006 Cisco Systems, Inc. All rights reserved.