Table Of Contents
SNMP Support for VPNs
The SNMP Support for VPNs feature allows the sending and receiving of SNMP notifications (traps and informs) using VPN routing and forwarding (VRFs) tables. In particular, this feature adds support to Cisco IOS software for the sending and receiving of SNMP notifications (traps and informs) specific to individual Virtual Private Networks (VPNs).
The SNMP Support for VPNs feature provides configuration commands that allow users to associate SNMP agents and managers with specific VRFs. The specified VRF is used for the sending of SNMP notifications (traps and informs) and responses between agents and managers. If a VRF is not specified, the default routing table for the VPN is used.
Configuration information is included in the "Configuring SNMP Support" module of the Cisco IOS Network Management Configuration Guide, Release 12.4, at the following URL:
The following sections provide information about this feature:
•SNMP Support for VPNs
•Configuring SNMP Support for VPNs
•Configuring SNMP Support for VPNs: Example
For a complete list of features included in the "Configuring SNMP Support" module, see the Feature Information table located near the end of the module.
Command Reference Information
This feature has no new or modified commands.
Master Commands Lists
Cisco IOS Master Commands List, All Releases provide an alphabetical list of all Cisco IOS commands in a Cisco IOS release.
Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.
© 2006-2007 Cisco Systems, Inc. All rights reserved.