Certificate - Storage Location Specification

Table Of Contents

Certificate - Storage Location Specification

Certificate - Storage Location Specification

---

This feature allows you to specify the storage location of local certificate for platforms that support storing certificates as separate files. All Cisco platforms support NVRAM, which is the default location, and flash local storage. Depending on your platform, you may have other supported local storage options including bootflash, slot, disk, USB flash, or USB token.

Configuration Information

Configuration information is included in the "Storing PKI Credentials" chapter in the Cisco IOS Security Configuration Guide, Release 12.4T at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124tcg/tsec_c/part20/t_pki_st.htm

Command Reference Information

Command reference information is included in the Cisco IOS Security Command Reference, Release 12.2SR, at the following URL:

•http://www.cisco.com/univercd/cc/td/doc/product/software/ios122sr/cr/srsec_r

New or Modified Commands

The following commands are new or modified for this feature:

•crypto pki certificate storage

•show crypto pki certificates storage

Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.

© 2006 Cisco Systems, Inc. All rights reserved.