Table Of Contents
QoS: Match VLAN
The QoS: Match VLAN feature allows you to classify network traffic on the basis of the Layer 2 virtual local-area network (VLAN) identification number.
Note As of Cisco IOS Release 12.2(31)SB2, the QoS: Match VLAN feature is supported on Cisco 10000 series routers only.
Configuration information is included in the "Classifying Network Traffic" module of the Cisco IOS Quality of Service Solutions Configuration Guide, Release 12.4T at the following URL:
The following section provides information about this feature:
•Information About Classifying Network Traffic
For a complete list of features included in the "Classifying Network Traffic" module, see the Feature Information Table located toward the end of the module.
Command Reference Information
Command reference information is included in the Cisco IOS Quality of Service Solutions Command Reference, Release 12.2SB, at the following URL:
New or Modified Commands
The following commands are new or modified for this feature:
•match vlan (QoS)
•show policy-map interface
Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.
© 2006 Cisco Systems, Inc. All rights reserved.