FlexVPN and Internet Key Exchange Version 2 Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR 1000)
Introduction to FlexVPN
Introduction to FlexVPN
Last Updated: December 5, 2012
Internet Key Exchange Version (IKEv2), a next-generation key management protocol based on RFC 4306, is an enhancement of the IKE Protocol. IKEv2 is used for performing mutual authentication and establishing and maintaining security associations (SAs).
FlexVPN is Cisco's implementation of the IKEv2 standard featuring a unified paradigm and CLI that combines site to site, remote access, hub and spoke topologies and partial meshes (spoke to spoke direct). FlexVPN offers a simple but modular framework that extensively uses the tunnel interface paradigm while remaining compatible with legacy VPN implementations using crypto maps.
This configuration guide contains the following modules:
Configuring Internet Key Exchange Version 2 (IKEv2) and FlexVPN Site-to-Site
This module describes IKEv2 CLI required for FlexVPN site-to-site. The module is divided into basic and advanced sections.
The basic section introduces basic IKEv2 commands and describes IKEv2 smart defaults and the mandatory IKEv2 commands required for FlexVPN site-to-site. This module is a prerequisite for understanding subsequent chapters.
The advanced section describes global IKEv2 commands and how to override the default IKEv2 commands.
Configuring FlexVPN Server
This module describes FlexVPN server features, IKEv2 commands required to configure FlexVPN server, remote access clients and the supported RADIUS attributes.
Configuring FlexVPN Client
This module describes FlexVPN client features and the IKEv2 commands required for FlexVPN client.
Configuring IKEv2 Load Balancer
This module describes the IKEv2 Load Balancer Support feature and the IKEv2 commands required to configure the IKEv2 Load Balancer.
Appendix: FlexVPN RADIUS Attributes
This module describes the RADIUS attributes supported by FlexVPN server.
Appendix: IKEv2 and Legacy VPNs
This module contains configuration examples on how to configure legacy VPNs such as crypto maps and DMVPN with Internet Key Exchange Version 2 (IKEv2).
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1110R)
Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any examples, command display output, network topology diagrams, and other figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses or phone numbers in illustrative content is unintentional and coincidental.
© 2012 Cisco Systems, Inc. All rights reserved.