Command Reference vA5(1.0) and earlier, Cisco ACE Application Control Engine
KAL-AP UDP Configuration Mode Commands
Downloads: This chapterpdf (PDF - 43.0KB) The complete bookPDF (PDF - 28.65MB) | Feedback

KAL-AP UDP Configuration Mode Commands

Table Of Contents

KAL-AP UDP Configuration Mode Commands

(config-kalap-udp) ip address


KAL-AP UDP Configuration Mode Commands

The ACE supports secure KAL-AP for MD5 encryption of data between the ACE and the Global Site Selector (GSS). To configure secure KAL-AP on the ACE, access KAL-AP UDP configuration mode using the kalap udp command. The CLI prompt changes to (config-kalap-udp). Use the no form of this command to return to configuration mode (or use the exit command).

kalap udp

no kalap udp

Syntax Description

This command has no keywords or arguments.

Command Modes

Configuration mode

Admin and user contexts

Command History

ACE Module Release
Modification

A2(1.0)

This command was introduced.


ACE Appliance Release
Modification

A3(1.0)

This command was introduced.


Usage Guidelines

The ACE supports secure KAL-AP for MD5 encryption of data between the ACE and the GSS. For encryption, you must configure a shared secret as a key for authentication between the GSS and the ACE context.

Examples

To enter KAL-AP UDP configuration mode, enter:

host1/Admin(config)# kalap udp
host1/Admin(config-kalap-udp)#

Related Commands

show kalap udp load
show running-config
(config-kalap-udp) ip address

(config-kalap-udp) ip address

To enable secure KAL-AP, you configure the VIP address to the GSS and the shared secret using the
ip address command. Use the no form of this command to remove the VIP address and the shared secret from the configuration.

ip address ip_address encryption md5 secret

no ip address ip_address

Syntax Description

ip_address

VIP address for the GSS. Enter the IP address in dotted-decimal notation (for example, 192.168.11.1).

secret

Shared secret between the GSS and the ACE. Enter the shared secret as a case-sensitive string with no spaces and a maximum of 31 alphanumeric characters.


Command Modes

KAL-AP UDP configuration mode

Admin and user contexts

Command History

ACE Module Release
Modification

A2(1.0)

This command was introduced.


ACE Appliance Release
Modification

A3(1.0)

This command was introduced.


Usage Guidelines

The ACE supports secure KAL-AP for MD5 encryption of data between the ACE and the Global Site Selector (GSS). For encryption, you must configure a shared secret as a key for authentication between the GSS and the ACE context.

Examples

To enable secure KAL-AP and configure the VIP address for the GSS and the shared secret, enter:

host1/Admin(config)# kalap udp
host1/Admin(config-kalap-udp)# ip address 10.1.0.1 encryption md5 andromeda
 
   

To disable secure KAL-AP, enter:

host1/Admin(config-kalap-udp)# no ip address 10.1.0.1

Related Commands

show kalap udp load
show running-config
(config) kalap udp