Table Of Contents
Important Electrostatic Discharge and System Grounding Information for Cisco SCE 8000, Release 4.0.x
First Published: May 27, 2013Release: 4.0.0
Note This document supports all 4.0.x releases.
Before you install the Cisco SCE8000 chassis or touch the modules, read this document.
For more information on installing the Cisco SCE8000 platform, see either the Cisco SCE8000 10GBE Installation and Configuration Guide or the Cisco SCE8000 GBE Installation and Configuration Guide.
Preparing Your Location
Make sure that your building is correctly grounded to earth ground.
Preparing the Rack Room
•Make sure that the rack enclosures are properly connected to the building earth ground.
•Make sure that the chassis is kept in a sealed antistatic bag prior to installation.
Make sure that you are properly grounded before you remove the antistatic bag from the chassis.
Precautions When Unpacking a Chassis
Make sure you are properly grounded when removing the antistatic bag from the chassis.
Precautions When Installing a Chassis
Make sure that you are properly grounded and that you properly handle the chassis during installation.
Grounding the Chassis
•Make sure you properly connect the chassis (system) ground to the building ground.
•The chassis illustration below shows the system ground connector pad location for the Cisco SCE8000 chassis.
•The ground lug kit part number is 69-0815-01.
Transporting Line Cards
Keep the line card in a sealed antistatic bag when transporting.
Handling Line Cards
•Properly ground yourself before you remove the line card from the antistatic bag.
•Handle the line card by the front panel and the metal carrier only.
Removing and Installing Line Cards
•Make sure you are properly grounded before removing or installing line cards.
•Make sure you properly handle the line card by the front panel and the metal carrier only.
Grounding the Work Surface
•Make sure that you and the work surface that you are placing the line card on are properly grounded.
•Your wrist strap, the rack enclosure, and the work surface should all be attached to the building ground.
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1110R)
Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use o f actual IP addresses in illustrative content is unintentional and coincidental.
© 2013 Cisco Systems, Inc. All rights reserved.