Cisco DistributedDirector 4700-M Install and Config Guide
Compliance and Safety Information
Downloads: This chapterpdf (PDF - 29.0KB) | Feedback

Compliance and Safety Information

Table Of Contents

Compliance and Safety Information

For United Kingdom Use Only

Warnings

For European Community Use Only


Compliance and Safety Information


This appendix contains information required by international compliance and safety organizations.

This appendix contains the following sections:

For United Kingdom Use Only

For European Community Use Only

For United Kingdom Use Only

Cisco Systems declaration of operating conditions:

The Director is designed to meet the requirements of NET1 and NET2.

Warnings

Interconnection directly, or by way of other apparatus, of ports marked:

"Safety Warning — See instructions for use"

with ports marked or not so marked may produce hazardous conditions on the network and that advice should be obtained from a competent engineer before such a connection is made.

The ports marked "Ethernet," "10BaseT," "Token Ring," "Console," and "AUX" have a safety warning applied to them as follows:

"These ports do not provide isolation sufficient to satisfy the requirement of BS6301; apparatus connected to these ports should either have been approved to BS6301 or have previously been evaluated against British Telecommunications plc (Post Office) Technical Guides 2 or 26 and given permission to attach; any other usage will invalidate any approval given to this apparatus."

Connection of Power Supply. The Gateway Server is intended for use when supplied with power from a supply providing 220-240 VAC, 50/60 Hz up to 5 Amps.

Other usage will invalidate any approval given to this apparatus if as a result it ceases to comply with BS6301: 1989.

The Director is brought into service by the supplier.

For European Community Use Only

The following operating conditions are required within the European Community:

The ports marked "Ethernet," "10BaseT," "Token Ring," and "FDDI," "Console," and "AUX" are SELV circuits.

SELV circuits should only be connected to other SELV circuits.