Guest

T1/E1 & T3/E3

Hard Plug Loopback Test

Document ID: 9343

Updated: Jun 23, 2005

   Print

Introduction

This document provides a flowchart for the hard plug loopback test.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Flowchart

Click the command boxes in the diagram for more information.

t1_flchrt_loop.gif

Related Information

Loopback Plug Enter these commands Prepare for the Extended Ping Test Prepare for the Extended Ping Test Perform Extended Ping Tests Perform Extended Ping Tests Perform Extended Ping Tests Perform Extended Ping Tests

Updated: Jun 23, 2005
Document ID: 9343