CUE FAQ: How do I enable HTTPS access for the CUE GUI?

Available Languages

Download Options

  • PDF     (4.7 KB)
    View with Adobe Reader on a variety of devices
Updated:July 27, 2013
Document ID:116381

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document describes how to enable HTTPS access for the Cisco Unity Express (CUE) GUI.

Prerequisites

Requirements

Cisco recommends that you have knowledge of these topics:

  • Cisco Unity Express 
  • HTTPS

Components Used

The information in this document is based on Cisco Unity Express version 8 and later. 

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

How do I enable HTTPS access for the CUE GUI?

Complete these steps in order to enable HTTPS access for the CUE GUI:

  1. In CUE CLI config mode, run the crypto key generate rsa label gui modulus 1024 command.
  2. Reload CUE.
  3. In CUE CLI config mode, run the web session security keyLabel gui command.
  4. Enable Transport Layer Security (TLS) 1.0 in Microsoft Internet Explorer and Mozilla Firefox.
  5. In the browser address bar, enter https://<cue-ip-address> OR http://<cue-ip-address>:443.

Revision History

Revision Publish Date Comments
1.0
27-Jul-2013
Initial Release
TAC Authored

Contributed by Cisco Engineers

  • Udit Mehrotra
    Cisco TAC Engineer.

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products