Guest

Cisco Unified MeetingPlace

MeetingPlace Server Siemens HiPath 4000 Configuration Example

Document ID: 63385

Updated: Jan 31, 2006

   Print

Introduction

This document provides a sample configuration for the Cisco MeetingPlace 8100 series with a Siemens HiPath 4000 PBX system. When you configure, you must program the T1 trunks as either TIE type trunks or EMI/Wink, not Wink/Immediate.

If you do not make these changes, there is no Dual Tone Multifrequency (DTMF) to or from Cisco MeetingPlace. To confirm that DTMF exists both to and from Cisco MeetingPlace, test the outdial by using the activity command.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

The information in this document is based on these software and hardware versions:

  • Cisco MeetingPlace 8100 Series MeetingPlace Server

  • Siemens HiPath 4000 PBX

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Configure

In this section, you are presented with the information to configure the features described in this document.

Siemens HiPath 4000 Configuration

This is a printout of a Siemens HiPath 4000 configuration.

pce-1.gif

pce-2.gif

pce-3.gif

Configuration

This document uses this configuration:

maui-soho-01#show running-config
Building configuration...
 .
 .
 .
 username maui-nas-05 password cisco

!--- The username for the remote router (maui-nas-05) 
!--- and shared secret (used for CHAP authentication).

 ip subnet-zero
 .
 .
 .
 !
 end

Verify

There is currently no verification procedure available for this configuration.

Troubleshoot

There is currently no specific troubleshooting information available for this configuration.

Related Information

Updated: Jan 31, 2006
Document ID: 63385