This document provides a sample configuration for the Cisco MeetingPlace 8100 series with a Siemens HiPath 4000 PBX system. When you configure, you must program the T1 trunks as either TIE type trunks or EMI/Wink, not Wink/Immediate.
If you do not make these changes, there is no Dual Tone Multifrequency (DTMF) to or from Cisco MeetingPlace. To confirm that DTMF exists both to and from Cisco MeetingPlace, test the outdial by using the activity command.
There are no specific requirements for this document.
The information in this document is based on these software and hardware versions:
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
In this section, you are presented with the information to configure the features described in this document.
This is a printout of a Siemens HiPath 4000 configuration.
This document uses this configuration:
username maui-nas-05 password cisco
!--- The username for the remote router (maui-nas-05) !--- and shared secret (used for CHAP authentication).
There is currently no verification procedure available for this configuration.
There is currently no specific troubleshooting information available for this configuration.