The trace route (tracert) utility enables you to view a network packet that is in transit and determine the number of hops necessary for that packet to get to its destination. This document explains how to run the trace route utility in a Cisco Intelligent Contact Management (ICM) environment.
Cisco recommends that you have knowledge of these topics:
The information in this document is based on all versions of ICM.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
You can use the trace route utility in order to verify timely and reliable connections between ICM nodes. You can also use the utility if the ping command indicates request timeouts. For more information about the ping command, refer to Ping Utility Usage.
The trace route utility determines the route that a packet takes to a destination from a remote computer or computers. The utility shows you the number of hops as well as the device IP addresses where, in a network path, a route is broken or is incorrect.
When the trace route utility successfully runs, you see the message Trace complete. If the trace route does not complete, there is a network failure between the local and remote nodes. In most cases, the problem is a network device, such as an IP router or hub along the network path. In this event, contact your LAN administrator and provide each hop of the trace route.
The sample output in this section shows a successful connection. Issue the tracert command in order to start the trace route utility in a Microsoft OS environment.
Tracing route to 172.30.8.28 over a maximum of 30 hops:
1 <10 ms <10 ms <10 ms 220.127.116.11
2 <10 ms <10 ms <10 ms 172.24.72.2
3 20 ms 10 ms <10 ms 18.104.22.168
4 10 ms <10 ms 10 ms 22.214.171.124
5 71 ms 80 ms 70 ms 126.96.36.199
6 80 ms 70 ms 81 ms 188.8.131.52
7 80 ms 90 ms 70 ms 184.108.40.206
8 80 ms 90 ms 70 ms 172.30.7.39
9 141 ms 150 ms 130 ms 172.30.15.30
10 141 ms 140 ms 160 ms 172.30.8.28
In order to find valid parameters for the tracert command, check the Microsoft Windows Help files.