Cisco IPCC Express Fails to Log in to Agent Desktop

Available Languages

Download Options

  • PDF     (21.4 KB)
    View with Adobe Reader on a variety of devices
Updated:July 18, 2006
Document ID:45320

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document describes the Cisco Agent Desktop login failure after the installation of Cisco IP Contact Center (IPCC) Express 3.0(3), as well as the workaround for this login failure.

Note: The problem described in this document is resolved in IPCC Express version 3.0(4).

Prerequisites

Requirements

Cisco recommends that you have knowledge of these topics:

  • Cisco CallManager

  • Cisco IPCC Express

Components Used

The information in this document is based on these software and hardware versions:

  • Cisco IPCC Express 3.0(3)

  • Cisco CallManager 3.2(2c) with Service Pack F and later

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Problem

When you log in to Cisco Agent Desktop in an IPCC Express environment, a JTAPI error occurs with this error message:

IPCCExp-LoginFails-1.gif

Solution

The IPCC Express agent desktop must access the jtapi.tar file that is located on the IPCC Express server when the application starts:

\\Program Files\Cisco\Desktop_Config\Desktop\Agentins\JTAPI\jtapi.jar

If the agent desktop detects there is a mismatch between its jtapi.tar version and the jtapi.jar version on the Cisco IPCC Express server, the agent desktop must copy jtapi.jar on the Cisco IPCC server to itself. The problem described in this document occurs when the agent desktop fails to perform this function, and the jtapi.jar version on the agent desktop needs to be manually updated.

To manually update the file, copy the jtapi.jar file from the IPCC Express server to the agent desktop JTAPI client folder:

\\Program Files\Cisco\Desktop\bin\CiscoJTAPIClient\Lib\jtapi.jar

Related Information

Revision History

Revision Publish Date Comments
1.0
18-Jul-2006
Initial Release

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products